Error code reference

Amana Dryer Error Code Hot

Possible overheating condition detected; the microprocessor controller has detected temperature exceeding 220°F (104°C), all outputs are disabled (dryer shut down), and buzzer sounds for approximately 5 seconds.

SourceAmana Microwave - ADC AD-75THS ServiceManual-PH5 PastProduction OPL: RCC-10Section VI-A, page 50

Amana codes Amana dryer codes

Diagnostic procedure

The full Hot procedure

Step 1 is visible so you can confirm you are on the right page. The remaining steps, the ones that tell you whether to actually replace a part, unlock with any pass.

MyPros+ · DiagnosticsStep 1 preview

First diagnostic step

Wait for the temperature sensor to drop to 220°F or lower, then manually reset the microprocessor controller by closing and opening the program switch (PS) on the back side of the controller.

SourceAmana Microwave - ADC AD-75THS ServiceManual-PH5 PastProduction OPL: RCC-10Section VI-A, page 50

Unlock with pass

More steps, wiring diagram references, and verified part numbers

Includes expected resistance and voltage values, connector pinouts, and supersession notes for replacement parts.

Unlock Hot procedure $9.95

Or subscribe: $29/month for all codes plus Max diagnostics, with 70 Max messages a day. Plus applicable tax.

Where this code is documented

6 manuals in the MyPros+ library document this code for Amana dryer.

Models covered by the manuals that document this code

More models are covered than are listed here.

75,000+ service documents · 20,000+ error codes · 100+ brands

Get Started

$29/month · Cancel anytime · Or $9.95 3-day pass · Plus applicable tax

The full Hot procedure

Where this code is documented

Models covered by the manuals that document this code

Related Amana dryer error codes