Bosch Dishwasher Error Code E:14

E:14 means the dishwasher has detected a fault with the flow meter, the sensor that measures water entering the machine during the fill cycle. Because the flow meter signal is missing or unreliable, the control board switches to a timed fill mode as a backup. Water flow is still being detected by the heat pump, so the machine can continue operating, but the root cause needs to be repaired. The most likely culprits are a loose wire harness connection or a failed flow meter sensor.

A reset may temporarily clear the error code from the display, but it will return if the underlying fault with the flow meter or its wiring has not been corrected. The dishwasher will continue running in timed fill mode as a workaround, but the sensor problem needs to be resolved to restore normal operation and prevent potential overfill or underfill issues.

If the fix is simply reseating a loose wire harness connector, there is no parts cost involved. Replacing a flow meter or a water inlet assembly typically costs between $40 and $120 for the part, depending on the specific Bosch model. If a technician is hired for the repair, expect total costs in the range of $120 to $250 including labor.

Yes, in many cases. Start by checking the wire harness connected to the flow meter for loose connectors, pinched wires, or corrosion, and reseat any loose connections. If the wiring is intact, the flow meter or the water inlet assembly it is part of will need to be replaced, which is a moderate repair that requires some comfort with disassembling the dishwasher's water inlet area.

The dishwasher does switch to a timed fill fallback mode, so it can continue operating. However, running without accurate flow measurement means the machine is estimating water volume rather than measuring it, which could result in inconsistent wash performance over time. It is advisable to diagnose and repair the fault rather than leaving it unaddressed.