mypros+
Model reference

Bosch FD9108

Dishwasher

3 documents33 error codes

Available documentation

Service Manual

  • Fault Codes and Service Programmes5 pg
    Covers this model
  • Fault Codes and Service Programmes5 pg
    Covers this model
  • Fault Codes and Service Programmes5 pg
    Covers this model
MyPros+ Max

Diagnose your Bosch FD9108.

  • Step-by-step diagnostics from the service manual
  • Test values, resistance specs, and wiring references
  • Verified part numbers when replacement is needed
Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass · Plus applicable tax

Error codes (33)

CodeMeaning
E:00No error present in the appliance.E:01Communication error between the electronics (D-bus interface error).E:02Working relay for heater defective; pump control or pump switchover defective.E:03Working relay for auxiliary heater defective.E:04Ground fault at zeolite heater or safety relay heater defective; internal fault…E:05Triac for water switch motor defective; water switch is running continuously…E:06Door Hall sensor fault; wire to the Hall sensor interrupted or power module…E:07Fan defective or blocked, module on the fan defective (only on appliances with…E:08Heat exchanger valve leaky; heat pump detects too low water level in pump sump.E:09Heating circuit interrupted (resistance, supply wires, contacts of the safety…E:10Zeolite heater heating circuit interrupted (resistance/supply wires), fan…E:11NTC resistance values outside permitted range, or wire/plug interrupted (low…E:12NTC resistance values outside permitted range (auxiliary drying system).E:13Water temperature too high (>75°C); protective measure, may not be an appliance…E:14Filling fault; no impulses from flow sensor although water is detected by heat…E:15Base carrier safety switch active; appliance cannot be switched off.E:16Water supply (impulses from flow sensor) without activation of the filling…E:17Water supply rate too high according to flow sensor.E:18Water supply rate too low according to flow sensor or no water supply.E:19Reserved.E:20Circulation pump fault; resistance values of heat pump wrong or heat pump…E:21Circulation pump fault (same as E:20); resistance values of heat pump wrong or…E:22Residual water in the pump sump due to dirty filters.E:23Drain pump fault; resistance values of drain pump wrong.E:24Non-return valve leaky or draining not possible due to drain pump cover missing…E:25Drain pump blocked or drain pump cover missing from pump sump.E:26Water switch fault; permanent activation of water switch or no impulses from…E:27Continuous undervoltage (<170V); not an appliance fault.E:28AquaSensor fault; appliance not equipped with AquaSensor or calibration of…E:29Undervoltage (<170V / 190V); not an appliance fault
View all 33 error codes
E:30Overvoltage (>290V); not an appliance faultE:31Reserved internal error code; not relevant to customer service.E:32Reserved internal error code; not relevant to customer service.

Related Bosch dishwasher models

75,000+ service documents · 20,000+ error codes · 100+ brands

Get Started

$29/month · Cancel anytime · Or $9.95 3-day pass · Plus applicable tax