Bosch Range Error Code F132

F132 on a Bosch range indicates a shorted meat probe input. The range detects this condition when the probe is actively in use during a cooking program and applies a 1-minute fault window before triggering the error. It means the probe circuit is returning an abnormally low resistance signal that the control board cannot interpret as a valid temperature. The most common cause is a damaged probe.

You should not continue using the meat probe function while this fault is active, as the control board cannot reliably monitor food temperature. Standard baking and broiling functions that do not involve the probe may still operate normally, but you should confirm the oven is otherwise functioning correctly before using it. If any other unexpected behavior occurs, stop using the appliance until the fault is resolved.

If the meat probe itself is the cause, replacement probes typically cost in the range of $25 to $75 depending on the model. If the probe jack requires replacement, parts and labor from a technician could run $100 to $250. A control board replacement, which is the most expensive scenario, can range from $200 to $500 or more including labor.

In many cases, yes. Start by removing the meat probe from the oven jack and inspecting it for visible damage such as kinks, burnt spots, or frayed cable. If the probe looks damaged, replacing it with a compatible Bosch probe is a straightforward repair most homeowners can perform without tools. If replacing the probe does not resolve the fault, further diagnosis of the jack and wiring may require a technician.

A power reset, such as turning off the circuit breaker for 30 seconds and restoring power, may temporarily clear the error code. However, if the underlying short condition in the probe or its circuit still exists, the fault will return as soon as the probe is inserted and a probe-based cooking program is started. A reset alone does not fix the root cause.