Electrolux Dishwasher Error Code Er 08

Er 08 means the main control board has detected that a tactile or touch switch on the user interface panel is bad or shorted. The board monitors each switch input continuously and triggers this code when it sees a switch that appears to be stuck in the closed position. The dishwasher will not operate normally until the fault is resolved.

A power reset by disconnecting the dishwasher from power for several minutes may temporarily clear the code, but it will return if the underlying hardware fault is still present. Er 08 is triggered by an active electrical condition, not a soft error, so a reset alone is not a permanent fix. The faulty switch, cable, or control board component must be addressed.

Repair costs depend on which component has failed. A replacement user interface panel typically costs between $50 and $150 for the part alone. A main control board can range from $100 to $250 or more. Adding professional labor, total repair costs commonly fall between $150 and $400 depending on the specific part needed and local service rates.

Some cases of Er 08 can be addressed by a knowledgeable DIYer, particularly if the cause is debris under a button or a visually damaged ribbon cable. However, if the user interface panel or control board needs replacement, the repair involves working with electrical components and disassembling the door panel, which requires comfort with appliance repair procedures. If you are unsure, a qualified technician is the safer option.

The dishwasher is designed to stop normal operation when Er 08 is active, which is a protective measure. Attempting to force operation with a shorted switch input could lead to unintended cycle behavior. It is best to leave the unit powered off until the fault is diagnosed and repaired.