Electrolux Dishwasher Error Code i5C

The i5C code means the dishwasher's hardware supervision circuit has detected abnormally high current in the drain pump's BLDC motor, measured at approximately 0.7 amps. The dishwasher stops operation to prevent damage to the motor or control board. This fault is typically caused by a jammed impeller, a wiring short, or a failing drain pump motor.

No, you should not continue running the dishwasher while this error is active. The fault indicates the drain pump motor is drawing excessive current, which can damage the motor windings, the motor driver on the PCB, or related wiring if operation continues. Address the cause before resuming use.

Repair costs depend on the root cause. If only a wire harness repair or connector cleaning is needed, costs are generally in the range of $75 to $150 for a service call. Drain pump replacement typically adds $100 to $250 in parts and labor. PCB replacement is the most expensive scenario, often ranging from $200 to $400 or more depending on parts availability.

Some causes are DIY-friendly. You can check the drain pump area for debris blocking the impeller and inspect the wire harness connections for obvious damage or loose connectors. If clearing a blockage or reseating a connector does not resolve the fault, replacing the drain pump motor or diagnosing the PCB is best handled by a technician with appropriate tools.

A reset may temporarily clear the code, but the error will return if the underlying cause is not corrected. If the drain pump impeller is jammed or the motor has an internal fault, the overcurrent condition will be detected again as soon as the drain cycle runs. Resetting without fixing the problem risks further damage.