Electrolux Dishwasher Error Code i92

The i92 error indicates a CCF checksum error, meaning the control board detected that its stored wash program configuration data failed an integrity check. The board cannot confirm the configuration data is valid, so it blocks all electronic functions as a precaution. The dishwasher will not start or respond to controls while this fault is active. Resolving it requires a power cycle at minimum, and potentially a control board replacement if the fault persists.

The i92 fault causes a complete electronic lockout, so the dishwasher will not operate at all while the error is active. There is no immediate safety hazard from the error itself, but you cannot use the appliance until the fault is resolved. The lockout is intentional and prevents the machine from running with potentially unreliable configuration data.

The main control board is the component involved in an i92 CCF checksum error, since the configuration data is stored in the board's internal memory. If the error persists after a power cycle, the control board is the part that will need to be replaced. No other sensor or mechanical component is associated with this specific fault code.

A power cycle is the recommended first step and may clear the i92 code if the checksum failure was caused by a temporary glitch rather than actual data corruption. To reset, unplug the dishwasher or switch off the circuit breaker for several minutes, then restore power. If the i92 code returns after the reset, the control board's memory is likely permanently corrupted and a reset alone will not fix it.

If a power cycle resolves the issue, there is no parts cost involved. If the control board requires replacement, parts alone typically range from around $100 to $300 or more depending on the specific model, with professional labor adding additional cost. Getting a repair quote and comparing it to appliance age and replacement cost is worth considering before committing to a control board replacement.