Electrolux Dishwasher Error Code i95

The i95 error indicates a UIDATA checksum type mismatch, meaning the configuration file in the dishwasher's control system does not match the user interface board that is connected. As a result, the control cannot update the UI configuration data. This is a software-to-hardware compatibility issue most often caused by an incorrect or failed UI board.

A basic power reset is unlikely to clear i95 because the fault is caused by a persistent incompatibility between the configuration file and the UI board, not a temporary communication glitch. The underlying mismatch will remain after the appliance is powered back on. The error will continue to appear until the correct board is installed or the UI board is successfully reprogrammed.

If only reprogramming is needed, labor costs from a technician typically range from around 75 to 150 dollars depending on your location. If a UI board replacement is required, parts can range from approximately 100 to 250 dollars, with total repair costs including labor generally falling between 150 and 400 dollars. Getting a diagnostic visit from a qualified technician will give you a more precise estimate.

Some cases can be resolved by reprogramming the UI board, which may be possible with the right tools and technical knowledge. However, if the wrong board was installed or reprogramming fails, the UI board will need to be physically replaced, which requires disassembly of the door panel. A technician familiar with Electrolux dishwasher electronics is recommended if you are not comfortable with control board work.

The i95 fault indicates that the control system cannot properly communicate configuration data to the UI board, which means the dishwasher may not operate correctly or reliably. It is advisable to avoid using the appliance until the fault is resolved to prevent potential issues with cycle control or water management.