Electrolux Dryer Error Code E83

E83 indicates that the main control board has received a selector dial position signal it does not recognize. This means the code sent by the dial does not match any expected program position. The fault points to either the selector dial assembly or the main control board as the source of the problem.

A power reset may temporarily clear E83, but if the underlying fault in the selector dial or wiring remains, the code will return as soon as the dryer attempts to read the dial position again. A reset is useful for confirming whether the fault is intermittent, but it is not a repair.

Repair costs depend on the failed component. A replacement selector dial assembly typically costs between $30 and $80 for the part. A main control board is considerably more expensive, often ranging from $100 to $250 or more for the part alone. Adding professional labor will increase the total cost by roughly $80 to $150 depending on your area.

Some causes of E83 are accessible to a confident DIYer. Checking the wiring harness connector for corrosion, reseating loose terminals, and inspecting the dial for visible damage are all reasonable starting points. However, replacing the selector dial assembly or main control board typically requires basic electrical knowledge and comfort working inside the appliance.

The dryer will generally not run a cycle while E83 is active because the control board cannot confirm which program has been selected. Attempting to force operation is not recommended. The fault should be diagnosed and corrected before resuming normal use.