Frigidaire Dishwasher Error Code i10

The i10 code means the dishwasher did not reach the required water level within the allowed fill time, which is 90 seconds during a normal cycle or 30 seconds during a test cycle. The control board stops the cycle to protect the wash pump from running dry. This is most commonly caused by a closed water supply valve, low water pressure, or a restricted inlet valve.

Resetting the dishwasher may clear the displayed code temporarily, but the i10 error will return at the next cycle if the underlying fill problem has not been resolved. Address the root cause, such as opening the water supply valve or clearing a restriction, before attempting to run another cycle.

If the fix is simply opening a shutoff valve or straightening a kinked hose, there is no parts cost involved. If the water inlet valve needs to be replaced, parts typically range from $20 to $65 depending on the model, with professional labor adding $75 to $150 or more depending on your location and the service provider.

Start by checking that the water supply shutoff valve is fully open. Then inspect the inlet hose for kinks or restrictions. If the supply is open and unobstructed, check water pressure at nearby fixtures and examine the inlet valve screen for clogs. If those checks do not resolve the issue, the inlet valve solenoid may need to be tested and replaced.

The dishwasher is designed to stop and display i10 specifically to prevent the wash pump from running without adequate water, which could damage the pump. You should not attempt to bypass the error. Resolve the water supply issue before running the appliance again.