Frigidaire Dishwasher Error Code i11

The i11 code means the dishwasher did not reach the required water level within the allowed fill time: 120 seconds during a normal cycle or 60 seconds during a test cycle. The control board monitors how long the inlet valve has been open and triggers this fault when the water level sensor does not confirm a successful fill. The most common cause is a closed or restricted water supply valve.

Resetting the dishwasher can clear the i11 code temporarily, but the error will return on the next cycle if the underlying water supply problem has not been resolved. Address the root cause first, then reset the unit by canceling the cycle or cutting power briefly, and run a new cycle to confirm the fault is gone.

If the fix is simply opening a closed supply valve or straightening a kinked hose, there is no parts cost. Replacing a water inlet valve typically costs between $25 and $75 for the part, while a water level pressure switch generally runs $15 to $50. If a technician is needed for diagnosis and repair, total service costs including labor often range from $100 to $250 depending on the component involved.

Start by checking that the water shutoff valve supplying the dishwasher is fully open. If the valve is open, inspect the inlet hose for kinks and check the inlet valve screen for mineral buildup or debris. If those are clear, the water inlet valve solenoid or water level pressure switch may need testing and replacement.

The dishwasher will not complete a wash cycle while this fault is active because it cannot confirm adequate water has entered the tub. Running the unit repeatedly without resolving the fill issue will not cause immediate safety hazards, but it will not wash dishes effectively and could stress the pump or heating element if they operate without sufficient water.