Frigidaire Dishwasher Error Code i4

The i4 code means the dishwasher has detected a leak and water has collected in the base pan at the bottom of the unit. The appliance stops running to prevent further water damage. You need to identify and repair the source of the leak before the dishwasher can be used safely again. Common sources include the door gasket, inlet valve, drain hose, or pump seals.

A reset may temporarily clear the i4 code, but it will return as soon as the dishwasher runs again if the underlying leak has not been fixed. Before restarting, you must remove all standing water from the base pan. Resetting without repairing the cause of the leak does not resolve the problem and risks further water damage.

Repair costs vary widely depending on the source of the leak. A door gasket replacement is generally on the lower end of the cost range, typically between $20 and $80 for the part plus labor if applicable. Inlet valve or circulation pump replacements can run between $75 and $250 or more depending on parts and labor rates in your area. Diagnosing the exact leak source before ordering parts will help avoid unnecessary expense.

No, you should not continue running the dishwasher while the i4 code is active. A confirmed leak can cause water damage to your flooring, cabinetry, and subfloor. If there is visible overflow from the unit, shut off the water supply valve under the sink immediately. Resume use only after the leak source has been identified and repaired.

Start by shutting off the water supply and removing any water from the base pan. Then inspect the door gasket for cracks or separation, check hose connections for looseness, and look for signs of dripping around the inlet valve and pump area. If the leak source is a worn gasket or loose hose clamp, the repair may be straightforward. Internal pump or valve failures typically require part replacement and may need a qualified technician.