Frigidaire Dishwasher Error Code i95

The i95 code means there is a UIDATA checksum mismatch between the dishwasher's user interface board and its powerboard. The two boards are comparing configuration data during communication and finding that the checksum types do not match. This prevents the dishwasher from operating and requires both boards to be replaced to resolve the incompatibility.

No, a reset will not clear the i95 error. The fault is caused by a fundamental hardware incompatibility between the UI board and the powerboard configuration data, not a temporary software glitch. The mismatch will be detected again each time the boards attempt to communicate, so the error will return until both boards are replaced.

Because the repair requires replacing both the UI board and the powerboard, parts costs can range from roughly $150 to $350 or more depending on the specific model. If you hire a technician, labor charges will add to that total, typically bringing the overall repair cost into the range of $250 to $500 or higher. Getting a quote from a local appliance repair service before proceeding is advisable.

Resolving the i95 error requires replacing both the UI board and the powerboard as a matched pair, which involves disassembling the dishwasher's door panel and control area. A knowledgeable DIYer comfortable with appliance electronics can perform this repair, but the job does require care when handling control board components. If you are unsure about working with internal electronics, a qualified technician is the safer option.

The i95 error indicates that the control boards cannot communicate correctly with each other, which means the dishwasher will not operate normally. Attempting to run the appliance in this state is not recommended, as the control system cannot reliably manage cycle functions. You should avoid using the dishwasher until the repair is completed.