Frigidaire Dryer Error Code E62

E62 indicates a heating timeout caused by Thermal Limiter-2 being open. This applies to domestic gas models and international electric models. The control board detected that the heating system did not perform within the expected parameters, typically because the thermal limiter tripped open due to overheating. The most frequent trigger is a blocked exhaust vent preventing proper airflow.

You should not continue using the dryer while E62 is active. The error means the thermal safety system detected an overheating condition and shut down the heating circuit. Running the dryer without resolving the underlying cause, particularly a blocked vent, creates a potential fire hazard. Address the root cause before resuming normal operation.

Repair costs vary depending on what caused the fault. Cleaning a blocked vent yourself costs little to nothing, while professional duct cleaning typically runs between $80 and $150. Replacing Thermal Limiter-2 parts generally cost between $10 and $40 for the component, with labor adding $75 to $150 if a technician is involved. Replacing the NTC thermistor is similarly priced, putting most E62 repairs in the $20 to $200 range depending on how many components need attention.

Clearing a blocked vent duct is a straightforward task that most homeowners can handle without special tools. However, if Thermal Limiter-2 has opened, it requires replacement with the correct part, which involves accessing internal dryer components. Testing the NTC thermistor and wiring also requires a multimeter and comfort with electrical testing, so less experienced users may prefer to call a technician.

A simple power reset will not clear E62 if the underlying fault remains. If Thermal Limiter-2 has opened, it is a one-time device that does not reset and must be physically replaced. Even after installing a new limiter, the fault will return if the root cause such as a clogged vent or failed NTC sensor is not also corrected.