mypros+
Model reference

Frigidaire FARE1011MW0

Dryer

4 documents44 error codes6 service modes

Available documentation

Tech Sheet

  • Dryer Tech Data Sheet22 pg
    Covers this model

Service Manual

  • Electric Dryer12 pg
    Covers this model
  • Technical Service Manual 2013 Freestand Dryer82 pg
    Covers this model

Training

  • Technical Service Manual 2012-2013 Training Manual152 pg
    Covers this model
MyPros+ Max

Diagnose your Frigidaire FARE1011MW0.

  • Step-by-step diagnostics from the service manual
  • Test values, resistance specs, and wiring references
  • Verified part numbers when replacement is needed
Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass · Plus applicable tax

Error codes (44)

CodeMeaning
E11Fill time too longE21Water not pumping out fast enough.E31Moisture sensor faultE32Pressure sensor calibration problems.E35Pressure sensor indicates water overfill.E41Door open faultE42Lid lock device failure.E43Control board fails to lock lid.E44Lid closed sensing failure.E45Lid locked sensing failure.E46Lid lock command sensing failure.E49Lid incongruence between lid closed sensing and lid locked sensing.E4ALid locked triac sensing failure on control board.E51Motor relay/thermal limiter/locked rotor/motor centrifugal switch 1/harness/low…E52Motor relay stuck closedE53Motor faultE54Centrifugal switch 2/heater/thermal limiter-2/wiring faultE55Motor sensing failure on main boardE56Belt faultE57High current on inverter.E58High current on motor phase.E59Incongruence between real motor speed and expected motor speed.E5AHigh temperature on heat sink on control board.E5CVoltage too high on control board.E61Heater relay failureE62Heating timeoutE65High limit thermostat trip count too highE67Heater sensing failure on main boardE71NTC failureE72NTC failure
View all 44 error codes
E75Valve NTC (thermistor) failure.E81Program selector/encoder faultE82Key-stuck errorE91Communication error between UI board and control board.E92Communication error between UI board and control board.E93Software configuration errorE94Software configuration errorE97Software configuration errorEA1Line frequency out of limits (54Hz<Lf<46Hz for 50Hz system and 64Hz<Lf<56Hz for…EA2High line voltageEA3Low line voltageEA5Line amplitude sensing failure on main boardEAELine safe relay sensing failure.EF1Clogged drain pump.

Service modes (6)

  • diagnostic["1
  • Diagnostic Mode (Push Button Selection)["Wake up unit.","Turn cycle selector knob to the normal cycle position.","Press and hold the cycle…
  • Diagnostic Mode (Rotary Selection - no access to outlet)["Wake up unit.","Place cycle selector knob in presoak position.","Position temp knob all the way…
  • Diagnostic Mode (Rotary Selection - with access to outlet)["Unplug the unit.","While unplugged, place cycle selector knob in presoak position.","Position…
  • Full Control Reset (Rotary Selection - no access to outlet)["Wake up unit.","Place cycle selector knob in presoak position.","Position temp knob all the way…
  • Full Control Reset (Rotary Selection - with access to outlet)["Unplug unit.","While unplugged, place cycle selector knob in presoak position.","Position temp…

Full entry steps, exit procedures, and test sequences are available in Max.

Related Frigidaire dryer models

75,000+ service documents · 20,000+ error codes · 100+ brands

Get Started

$29/month · Cancel anytime · Or $9.95 3-day pass · Plus applicable tax