Frigidaire Dryer Error Code EA2

EA2 indicates that the dryer's control board has detected a main AC line voltage that exceeds safe operating limits, specifically above 264 Vrms on a 240V system or 138 Vrms on a 120V system. The code can also appear if the control board's microprocessor has become corrupted or if the board itself has failed. The dryer stops operating to prevent damage to internal components until the voltage condition is corrected or the board is replaced.

No, you should not attempt to run the dryer while EA2 is active. If the cause is genuinely high line voltage, operating the dryer could damage the heating element, motor, and control electronics. The dryer's shutdown behavior is a protective response, and the underlying cause should be diagnosed and corrected before resuming normal use.

If the cause is high utility voltage and no dryer components were damaged, there may be no parts cost at all, though an electrician's service call to inspect wiring could range from $75 to $200 or more depending on location. If the electronic control board needs to be replaced, parts and labor costs typically range from $150 to $400 depending on the specific board, local labor rates, and whether you hire a technician or perform the repair yourself.

The first step is to measure the voltage at the dryer's wall outlet or terminal block using a true RMS multimeter. If voltage is too high, that is a utility or home wiring problem requiring an electrician or utility provider, not a dryer repair. If line voltage is normal, attempting a restart is the next step, and if the error persists, the electronic control board will need to be replaced, which is a task many experienced DIYers can perform with the correct replacement part.

A reset may temporarily clear the code, but if the root cause has not been addressed, the error will return. If high line voltage is the problem, restarting without correcting the supply voltage will not resolve anything. If the issue is a corrupted microprocessor or a failed control board, resetting will not restore normal function and board replacement will be necessary.