Frigidaire Dryer Error Code E67

E67 on a Frigidaire dryer means the main electronic control board has experienced a heater sensing failure. The board contains internal circuitry that monitors the heating system, and when that circuitry fails, E67 is triggered. This code points directly to the control board as the defective component, not the heater element or temperature sensors.

A reset may temporarily clear the display, but E67 will return because the underlying cause is a defective main control board. The fault is hardware-based, meaning the sensing circuitry on the board cannot recover through a power cycle. Replacement of the board is required to permanently resolve the code.

If you replace the main control board yourself, parts typically cost in the range of $100 to $250 depending on the specific model. If you hire a technician, total repair costs including labor generally fall between $200 and $400. Getting a quote before proceeding is a good idea, as costs vary by region and service provider.

A knowledgeable DIYer comfortable working with appliance electronics can replace the main control board. The repair involves disconnecting power, accessing the control panel, unplugging the board connectors, and installing the new board. If you are not comfortable working with appliance electronics, a certified technician is the safer choice.

Running the dryer with an active E67 code is not recommended. Because the control board cannot properly sense heater operation, it may be unable to regulate heat correctly or respond to overheating conditions. Continuing to operate the dryer in this state could pose a safety risk.