GE Washer Error Code E14

E14 on a GE washer is an overflow error, meaning the water level inside the drum reached or exceeded the maximum safe threshold. The washer stops the cycle automatically to prevent water from spilling out. This fault is most commonly caused by a water inlet valve that is not shutting off properly, though a faulty pressure switch or drain obstruction can also trigger it.

No, you should not continue using the washer until the cause of E14 has been identified and corrected. The overflow condition means water is or was rising to an unsafe level, which can result in water damage to your floor, subfloor, or surrounding cabinetry. Turn off the water supply to the washer until you have diagnosed the problem.

Repair costs vary depending on the failed component. A replacement water inlet valve typically costs between $25 and $80 for the part, while a pressure switch generally falls in the $15 to $50 range. If you hire a technician, expect to add $75 to $150 or more for labor depending on your area and the complexity of the repair.

Start by inspecting the water inlet valve for any signs of leaking or failure, since a valve that does not close fully is the most frequent cause. Next, check the pressure switch hose for kinks or blockages and confirm the drain hose and pump filter are clear. If the valve is found to be faulty, replacing it is typically required to resolve the error. If basic checks do not reveal the cause, testing the pressure switch with a multimeter may be necessary.

A reset may temporarily clear the E14 code, but the error will return if the underlying problem has not been fixed. If the inlet valve is stuck open or leaking, water will continue to overfill the tub on the next cycle and trigger the fault again. Address the root cause before running another wash cycle.