mypros+
Model reference

GE GCRH410F

Washer

1 document35 error codes2 service modes

Available documentation

Service Manual

  • GE 3.5 pieds cubes Service Manual79 pg
    Covers this model
MyPros+ Max

Diagnose your GE GCRH410F.

  • Step-by-step diagnostics from the service manual
  • Test values, resistance specs, and wiring references
  • Verified part numbers when replacement is needed
Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass

Error codes (35)

CodeMeaning
E11Fill time too longE13Water leak in the tub or air leak in the air bell.E14Dispenser drawer switch fault.E21Water does not drain fast enough.E23Drain pump relay on the control board is defective.E24Drain pump relay on the control board is defective.E31Pressure sensor does not communicate with the control board (better models).E35Pressure sensor indicates excess water (better models).E41Control board receives signal that door switch is open.E42Door remains locked after end of cycle.E43Control board problem.E44Control board problem.E45Control board problem.E46Control board problem.E47Control board receives signal that door is open during spin.E48Control board receives signal that door is closed (when it should not be).E52Bad signal from the speed analyzer (tachometer).E55Motor overheating.E56Motor current is high.E57Speed control current is high.E58High current at motor winding.E59No signal from speed analyzer for 3 seconds.E5AHigh temperature at cooling fins on the speed control board.E5BHigh temperature at cooling fins on the speed control board.E5CHigh temperature at cooling fins on the speed control board.E5DCommunication problem between control boards.E5ECommunication problem between control boards.E5FCommunication problem between control boards.E67Incoming microprocessor voltage is incorrect.E95Communication error.
View all 35 error codes
EB1Incoming power frequency is out of limits.EB2Incoming voltage is above 130 VAC.EB3Incoming voltage is below 90 VAC.EF1Drain pump is clogged.EF2Too much soap/detergent.

Service modes (2)

  • Diagnostic Test Mode["Turn the program selector knob to the start position (Drain/Spin).","Press Pause/Cancel to turn…
  • Error Code Recall["Press any button to reset the washer.","Wait 5 seconds.","Press and hold START and Pause/Cancel…

Full entry steps, exit procedures, and test sequences are available in Max.

Related GE washer models

78,000+ service manuals · 160,000+ error codes · 55+ brands

Get Started

$29/month · Cancel anytime · Or $9.95 3-day pass