GE Washer Error Code E24

E24 on a GE washer means the inverter drive board detected an under-voltage condition immediately after the motor attempted to start. The inverter shut down as a protective measure to prevent internal damage. This code can be caused by low household supply voltage, a weak outlet circuit, a faulty inverter board, or a problem with the drive motor or its wiring.

No, you should not continue running the washer while E24 is active. The inverter has shut down to protect itself and the motor from damage caused by under-voltage operation. Running the machine without resolving the root cause could worsen the fault and potentially damage the inverter board or motor, turning a simpler repair into a more costly one.

Repair costs vary depending on the root cause. If the issue is simply a low-voltage outlet or a loose connection, there may be little or no parts cost, though an electrician visit could run anywhere from $75 to $200 or more. If the inverter board needs replacement, parts and labor together typically range from $150 to $400 depending on the model and service rates in your area. A failed drive motor can push costs higher, often in the $200 to $500 range including labor.

Some causes of E24 are DIY-friendly. Start by measuring your outlet voltage with a multimeter to confirm it falls between 120 VAC and 132 VAC. You can also check that the washer is plugged directly into a dedicated outlet and inspect visible wiring connectors for looseness or corrosion. If the power supply checks out and the fault persists, replacing the inverter board or drive motor typically requires more technical skill and comfort working with appliance electronics.

A reset may temporarily clear the E24 code, but the error will return if the underlying cause is not corrected. If the fault is caused by low supply voltage, a weak circuit connection, or a failing component, those issues must be resolved first. Use a reset only as part of testing after you have addressed the suspected cause, not as a standalone fix.