KitchenAid Oven Error Code F5E6

F5E6 indicates that the oven's control board is detecting a contradiction between the door lock mechanism and the door position sensor. The latch switch is reporting a locked condition while the door switch is reporting that the door is open, which cannot occur during normal operation. This conflict causes the control board to halt operation and display the fault code. The most likely causes are a failed door switch, a faulty latch switch, or a latch assembly that is mechanically stuck.

You should not use the oven while this code is active. The fault indicates a problem with the door locking system, and the control board may restrict oven operation to prevent further damage to the latch assembly. Using the oven with a malfunctioning latch system could also leave the door unlocked during a self-clean cycle, which operates at very high temperatures.

Repair costs vary depending on which component has failed. A replacement door switch or latch switch typically ranges from $15 to $60 for the part, while a complete latch assembly can run from $50 to $150. If a professional technician is needed, labor costs generally add $100 to $200 depending on your area, bringing total repair costs for most F5E6 faults into the range of $120 to $350.

Inspection of the door switch and latch switch is within reach for a knowledgeable DIYer comfortable using a multimeter to test switch continuity. Checking for loose wiring connectors and clearing any physical obstruction from the latch cavity also requires no special tools. However, if the latch motor or control board needs replacement, working with the internal wiring of the oven requires disconnecting power and exercising caution around high-voltage components.

A power reset by disconnecting the oven from the outlet or shutting off the circuit breaker for several minutes may temporarily clear the code. However, if the underlying cause is a failed switch or a stuck latch mechanism, the fault will return as soon as the control board runs its diagnostics again. A reset alone does not fix the problem and should be followed by a proper inspection of the door switch and latch switch.