Error code reference

Samsung Heat Pump Error Code t3

Error of PWM discharge temperature sensor (OPEN/SHORT) - detected when outdoor temperature is over -10°C; error level: over 4.95V (-30°C) or below 0.5V (151°C).

SourceSamsung Heat Pump - Troubleshooting Guide: Outdoor Unit Error Codes (RMBH100GAM0SER)p. 181, 193

Samsung codes Samsung heat pump codes

Diagnostic procedure

The full t3 procedure

Step 1 is visible so you can confirm you are on the right page. The remaining steps, the ones that tell you whether to actually replace a part, unlock with any pass.

MyPros+ · DiagnosticsStep 1 preview

First diagnostic step

Check if sensor connector is departed from PCB; measure resistance across sensor terminals and compare to resistance table.

SourceSamsung Heat Pump - Troubleshooting Guide: Outdoor Unit Error Codes (RMBH100GAM0SER)p. 181, 193

Unlock with pass

More steps, wiring diagram references, and verified part numbers

Includes expected resistance and voltage values, connector pinouts, and supersession notes for replacement parts.

Unlock t3 procedure $9.95

Or subscribe: $29/month for all codes plus Max diagnostics, with 70 Max messages a day. Plus applicable tax.

Where this code is documented

9 manuals in the MyPros+ library document this code for Samsung heat pump.

Models covered by the manuals that document this code

75,000+ service documents · 20,000+ error codes · 100+ brands

Get Started

$29/month · Cancel anytime · Or $9.95 3-day pass · Plus applicable tax

The full t3 procedure

Where this code is documented

Models covered by the manuals that document this code

Related Samsung heat pump error codes