Whirlpool Dishwasher Error Code FCE4

FCE4 indicates a problem with the Antenna B circuit, specifically a loose or faulty connection detected by the control system. The dishwasher has lost the expected signal continuity from Antenna B and has stored this fault code as a result. Resolving it requires inspecting all connections in the Antenna B circuit and repairing or replacing any damaged components.

The FCE4 code points to a communication or sensing circuit fault, and running the dishwasher while this fault is active is not recommended. The appliance may not operate as intended, and continuing to run it could mask other developing issues. It is best to address the fault before resuming normal use.

If the fix is simply reseating a loose connector, you may incur only a service call fee, typically in the range of $75 to $150 depending on your area. If the Antenna B component or wiring harness needs replacement, total repair costs including parts and labor could range from $150 to $350 or more. Control board replacement, if required, would fall on the higher end of repair estimates.

Start by disconnecting power to the dishwasher, either by unplugging it or turning off the circuit breaker. With power off, locate and inspect all connectors in the Antenna B circuit, reseating any that are loose. If connections appear intact and the code returns after restoring power, the Antenna B component itself may need to be replaced.

A reset may temporarily clear the FCE4 code from the display, but if the underlying connection problem in the Antenna B circuit has not been fixed, the code will return. A reset alone is not a repair. The physical wiring and component must be inspected and corrected to resolve the fault permanently.