Error code reference

Whirlpool Range Error Code E0

Sub-code used with F1 (EEPROM communications), F2 (UL A/D errors), F3 (oven sensor opened), or F5 (door and latch switches do not agree).

SourceWhirlpool Freestanding Self-Clean Gas Range - Service Manual (SF/FGS/TGS Series)p. 4-14

Whirlpool codes Whirlpool range codes

Diagnostic procedure

The full E0 procedure

Step 1 is visible so you can confirm you are on the right page. The remaining steps, the ones that tell you whether to actually replace a part, unlock with any pass.

MyPros+ · DiagnosticsStep 1 preview

First diagnostic step

Verify failure if not displayed. Go to Diagnostics screen 5 (A-Last Fault Code / B-Cleared Error Code) and clear the error code by pressing the START key.

SourceWhirlpool Range - Tech Sheet: W10116300Ap. 2

Unlock with pass

More steps, wiring diagram references, and verified part numbers

Includes expected resistance and voltage values, connector pinouts, and supersession notes for replacement parts.

Unlock E0 procedure $9.95

Or subscribe: $29/month for all codes plus Max diagnostics, with 70 Max messages a day. Plus applicable tax.

Where this code is documented

13 manuals in the MyPros+ library document this code for Whirlpool range.

Models covered by the manuals that document this code

More models are covered than are listed here.

75,000+ service documents · 20,000+ error codes · 100+ brands

Get Started

$29/month · Cancel anytime · Or $9.95 3-day pass · Plus applicable tax

The full E0 procedure

Where this code is documented

Models covered by the manuals that document this code

Related Whirlpool range error codes