Model reference

Amana OL170E/P96364-3F

Furnace

3 documents37 error codes5 service modes

Available documentation

Tech Sheet

tech-sheet-W10859290-RevA.pdf16 pg
Covers this model

Installation Guide

Installation Instructions10 pg
Covers this model
Instrucciones de instalacion2 pg
Covers this model

MyPros+ Max

Diagnose your Amana OL170E/P96364-3F.

Step-by-step diagnostics from the service manual
Test values, resistance specs, and wiring references
Verified part numbers when replacement is needed

Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass

M+

M+ Max·Amana Furnace

1-1 on my Amana OL170E/P96364-3F

M+

Power relay K2 stuck in closed (active)

From Tech Sheet W12647453, p.25:

1.Access service mode to confirm the active fault code and read stored error history.

2.Measure control board supply voltage at test points. Expected: 12 VDC and 5 VDC.

3.Inspect all connectors on the main control for corrosion or backed-out pins.

Part WPW10804018

Electronic control board

Error codes (37)

CodeMeaning

1-1Power relay K2 stuck in closed (active) position, detected by control module.1-2Control module software problem 10-1Dispenser electrical problem 10-3Drying fan error 2-1Stuck key detected 2-2No response from user interface 3-1Thermistor/soil sensor open circuit 3-2Thermistor/soil sensor short circuit 3-3Soil sensor (OWI) calibration failure 4-3Wash motor non-operation 5-1Door switch stuck open 5-2Door switch stuck closed 6-1No water / insufficient water level in pump (mechanical problem).6-2Fill valve electrical problem 6-3Suds/air in pump 6-4Overfill float switch stuck in overfill position or dishwasher not level, or…6-7Flow meter disconnected or damaged.6-8Regeneration electrical problem 7-1No heat 7-2Heater element stuck in active mode 8-2Drain motor electrical problem 8-3Drain circuit constantly powered 9-1Unable to determine diverter valve position 9-2Diverter valve stuck 9-3Diverter disc missing 9-4Lower spray arm error F0No error present.F10Display error.F2KKey or foil pressed more than 1 minute.F2TTouch panel pressed more than 1 minute.

View all 37 error codes

F3HHumidity sensor out of range.F3TTemperature sensor out of range.F7Power to magnetron interrupted.F9CE2PROM CheckSum error.F9EE2PROM empty.F9ME2PROM missing.F9WE2PROM write error.

Service modes (5)

Customer Program Fast Forward ModeAfter starting a customer program, press HI TEMP
Error History ClearDuring the service diagnostic program at the error display interval, press the HI TEMP (high…
Service Diagnostic Program1
Touch Panel and Microcomputer Board Test (Self-Diagnostic)["Press the clock key.","Press keys 1, 2, and 3 on the keyboard.","Touch AM/PM on the touch screen…
Touch Panel and Microcomputer Board Test Mode (Self-Diagnostic)["Press the CLOCK key.","Touch 'Hours' on the touch screen and set hours to '1'.","Touch 'Minutes'…

Full entry steps, exit procedures, and test sequences are available in Max.

Related Amana furnace models

78,000+ service manuals · 160,000+ error codes · 55+ brands

$29/month · Cancel anytime · Or $9.95 3-day pass