mypros+
Model reference

Jenn-Air JMW8530DAW

Oven

15 documents52 error codes30 service modes

Available documentation

Tech Sheet

  • Electric Wall Oven/Microwave⎯Technical Information11 pg
    Covers this model
  • Electric Wall Oven/Microwave—Technical Information11 pg
    Covers this model

Service Manual

  • Combination Electric Wall Ovens and Microwaves Service Manual45 pg
    Covers this model
  • JennAir Wall Oven MW JMW8527DA JMW8530DA JMW9527DA JMW9530DA MMW5530DA Service Manual 1602282145 pg
    Covers this model
  • Failure Codes and Wiring Diagrams for Maytag Heritage Gas & Electric Ranges124 pg
    Covers this model
  • Electric Wall Oven Service Manual60 pg
    Covers this model
  • FAILURE CODES AND WIRING DIAGRAMS for MAYTAG HERITAGE GAS & ELECTRIC RANGES124 pg
    Covers this model

Bulletin

  • Installation Bulletin - IDC-0004-B Updated Dimensions in Installation Instructions 8101P602-601 pg
    Covers this model
  • Technical Bulletin - TDC-0068B-B Hinge and Receptacle Modification2 pg
    Covers this model
  • Technical Bulletin TDC-0100A-B1 pg
    Covers this model
  • Technical Bulletin - Hinge and Receptacle Modification2 pg
    Covers this model

Service Flash

  • Service Update First HALF—200994 pg
    Covers this model
  • Repair Tip - Hinge and Receptacle Modification2 pg
    Covers this model

Installation Guide

  • Installation Instructions9 pg
    Covers this model
  • Installation Instructions21 pg
    Covers this model
MyPros+ Max

Diagnose your Jenn-Air JMW8530DAW.

  • Step-by-step diagnostics from the service manual
  • Test values, resistance specs, and wiring references
  • Verified part numbers when replacement is needed
Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass

Error codes (52)

CodeMeaning
1c1cShorted key detected on control keypad.1c2cKeyboard tail disconnected (single cavity or upper oven).1c31Cancel key circuit failure (single cavity or upper oven).1c32Cancel key circuit failure (lower oven).1c4cMicro communication failure.1c5cVcc or ground open circuit on control board.1c6cEEPROM error on control board.1c7cControl not calibrated.1c81Cook profile corrupted in EEPROM for upper/single oven cavity (CRC invalid).1c82Cook profile corrupted in EEPROM for lower oven cavity (CRC invalid).1c8cCooking profile corrupted in EEPROM.1d11Runaway temperature with door unlocked (single cavity or upper oven).1d12Runaway temperature with door unlocked (lower oven).1d21Runaway temperature with door locked (single cavity or upper oven).1d22Runaway temperature with door locked (lower oven).3d11Temperature sensor open (single cavity or upper oven).3d12Temperature sensor open (lower oven).3d21Temperature sensor shorted (single cavity or upper oven).3d22Temperature sensor shorted (lower oven).3d31Meat probe open (single cavity or upper oven).3d41Meat probe open (single cavity or upper oven, alternate code).3d51Meat probe not calibrated4d11Door switch input clean/open (single cavity or upper oven) during self-clean.4d12Door switch input clean/open (lower oven) during self-clean.4d21No cooling fan rotation / no RPM detected (single cavity or upper oven).4d22No cooling fan rotation / no RPM detected (lower oven).4d31Fan state error4d32Fan state error4d41Low cooling fan rotation when fan is supposed to be on (single cavity or upper…4d42Low cooling fan rotation when fan is supposed to be on (lower oven).
View all 52 error codes
4d51Door switch circuit failure4d52Door switch circuit failure9d11Door latch will not lock (single cavity or upper oven).9d12Door latch will not lock (lower oven).9d21Door latch will not unlock (single cavity or upper oven).9d22Door latch will not unlock (lower oven).9d31Door latch shows both locked and unlocked simultaneously (single cavity or…9d32Door latch shows both locked and unlocked simultaneously (lower oven).9d41Door latch shows neither locked nor unlocked (single cavity or upper oven).9d42Door latch shows neither locked nor unlocked (lower oven).F-Communication error between boards.F1Power to element relay activated during time of day display.F2Over temperature sensed by control.F3Cooling fan on with no oven function selected.F4Shorted oven sensor.F5Power element relays disabled in cook mode.F7Shorted key detected on control.F8Shorted meat probe alarm.F9Door lock safety circuit on power relay board sensed.FCCommunication error between boards.FFInvalid temperature reading on power relay board.FRSecond oven error sensed (double oven only).

Service modes (30)

  • 208/240 V Mode["1
  • Clear Stored Fault CodesEnter the fast test mode, then press both the Cook Time and Stop Time keys simultaneously for 5…
  • Clock and Temperature Display Change (12/24hr, °F/°C)Hold either Timer key down on power up
  • Control LockoutPress and hold BACK and ENTER pads for 5 seconds.
  • Demo Mode1
  • Diagnostic Code Display ModeEnter Service Mode then press 'Last Fault' to display last error code and oven configuration…
  • Diagnostic Code Display Mode (H1 Control)1
  • Diagnostic Code Display Mode (H1 Controls)Press and hold AUTOSET pad for 3 seconds at power-up.
  • Diagnostic Code Display Mode (H3 Controls)Press and hold Upper Cancel and Timer for 3 to 5 seconds within 5 minutes of power up.
  • Diagnostic Code Display Mode (NSC Controls)Press and hold the More + pad for 3 to 5 seconds when powering up the unit (within 60 seconds of…
  • Fast Test / Diagnostic Test ModeHold the Stop Time key down at power up, OR hold the Stop Time key down for 10 seconds within 5…
  • Faults Access (EOC III Controls)1
  • JJW Models Component TestTouch the desired function pad (Bake, Broil, Convect Bake, Convect Roast, Drying, or Clean) then…
  • One-Watt Standby Mode (NSC Controls)Press and hold Cancel and Less
  • Oven Temperature Adjustment["1
  • Quick Test Mode (EOC III Controls)1
  • Quick Test Mode (H1 Control)1
  • Quick Test Mode (H1 Controls - Convection Model)1
  • Quick Test Mode (H1 Controls - Non-Convection Model)1
  • Quick Test Mode (H2/H2.5 Controls)1
  • Quick Test Mode (H3 Controls)1
  • Quick Test Mode (M1/M2 Controls)1
  • Quick Test Mode (NSC Non-Self Clean Controls)1
  • Sabbath Mode["1
  • Service / Test Mode["1
  • Service Mode (EOC III Controls)1
  • Service/Test Mode1
  • Temperature Offset ChangeProgram bake above 500°F, repress bake pad and hold for 3-4 seconds (pad must be re-pushed within 3…
  • Test Mode (UH Controls)1
  • Test Mode (UH1/2 Control)1

Full entry steps, exit procedures, and test sequences are available in Max.

Related Jenn-Air oven models

78,000+ service manuals · 160,000+ error codes · 55+ brands

Get Started

$29/month · Cancel anytime · Or $9.95 3-day pass