Jenn-Air Oven Error Code 1d11

Error code 1d11 means the oven's control board has detected a runaway temperature condition while the door is unlocked. The temperature sensor is producing a resistance reading greater than 2293 ohms, which signals an abnormally high or uncontrolled oven temperature. As a safety response, the control board disables all outputs, shutting the oven down completely.

A power reset by turning off the circuit breaker for one to two minutes may temporarily clear the code, but if the underlying fault remains, the code will return once the oven attempts to operate. A reset is useful for confirming whether the fault is intermittent, but it is not a repair. The temperature sensor resistance and wiring should be tested before relying on the oven again.

Repair cost depends on the failed component. A replacement oven temperature sensor typically costs between $20 and $75 for the part, making it the least expensive fix. Control board replacement is significantly more costly, with parts often ranging from $150 to $400 or more depending on the model. Adding professional labor charges will increase the total, generally ranging from $100 to $200 for a service call and repair.

No, you should not use the oven while this code is active. The 1d11 code indicates a potential runaway heating condition, and the control has already disabled the oven as a precaution. Attempting to bypass or reset the oven without diagnosing the root cause could allow uncontrolled heating, which is a fire and safety hazard.

Start by measuring the resistance of the oven temperature sensor with a multimeter. A reading above 2293 ohms at room temperature indicates the sensor needs replacement. If the sensor tests within normal range, inspect the wiring harness and connectors between the sensor and control board for damage or corrosion. If both the sensor and wiring check out, the control board may need to be evaluated or replaced.