Skip to main content
Error code reference
Jenn-Air Oven Error Codes
166 error codes documented with diagnostic procedures.
Have your model number? Get codes specific to your unit.
1c1cShorted key detected on the control panel; key press continuously sensed.1c2cKeyboard tail disconnected; keyboard loop reading improper value.1c31Cancel key circuit problem; cancel key reading improper value (upper oven/single cavity).1c32Cancel key circuit problem; cancel key reading improper value (lower oven).1c4cMicro communication failure1c5cVoltage-to-current converter or ground fault at measurement point.1c6cEEPROM error1c7cControl not calibrated; calibration value out of range1c81Cook profile corrupted in EEPROM (upper oven or single cavity, UH1/2 control).1c82Cook profile corrupted in EEPROM for lower oven-CRC invalid.1c8cCooking program error1d11Runaway temperature (650°F) detected with door unlocked; sensor resistance exceeds 2237…1d12Runaway temperature (650°F) detected with door unlocked; sensor resistance exceeds 2237…1d21Runaway temperature (950°F) detected with door locked; sensor resistance exceeds 2787…1d22Runaway temperature (950°F) detected with door locked; sensor resistance exceeds 2787…3d11Temperature sensor open; sensor resistance reads infinite ohms (upper oven/single cavity).3d12Lower oven temperature sensor failure (open)-sensor resistance is infinite.3d21Temperature sensor shorted; sensor resistance reads approximately 0 ohms (upper…3d22Temperature sensor shorted; sensor resistance reads approximately 0 ohms (lower oven).3d31Meat probe open (single cavity or upper oven).3d41Meat probe open (single cavity or upper oven, alternate code).3d51Meat probe not calibrated4d11Door switch position failure4d12Door switch position failure4d21No reverse airflow fan rotation (no/low RPM) during cook or clean (upper oven or single…4d22No reverse airflow fan rotation (no/low RPM) during cook or clean (lower oven, UH1/2…4d31Reverse airflow fan state error4d32Reverse airflow fan state error4d41Low cooling fan rotation when fan is supposed to be on (single cavity or upper oven).4d42High reverse airflow fan rotation, high RPM (lower oven, UH1/2 control).4d51Door switch circuit failure; door switch not reading open or closed (upper oven/single…4d52Door switch circuit failure; door switch not reading open or closed (lower oven).9d11Latch will not lock; lock switch not reading closed (upper oven/single cavity).9d12Door latch will not lock9d21Door latch will not unlock9d22Door latch will not unlock9d31Door latch state unknown9d32Door latch both locked and unlocked simultaneously in lower oven-lock and unlock switches…9d41Door latch shows neither locked nor unlocked (single cavity or upper oven).9d42Door latch shows neither locked nor unlocked (lower oven).9d51Both lock and unlock states are unknown; latch switch not locked or unlocked.9d61Door position switch open circuit detected during clean cycle.FFault code indicated by F plus a number appearing in the display, indicating an…F0No fault codes sensed in that portion of the system (indicates no stored faults).F0E0No fault detected (default/good status).F1Oven temperature errorF1-3Shorted key on keyboard.F1-4Keyboard disconnected.F1E0Internal faultF1E1Internal oven Appliance Manager errorF1E1-0Main ACU faultF1E1-1Main ACU faultF1E1-4Main ACU faultF1E1-5Main ACU faultF1E1-6Main ACU faultF1E1-7Main ACU faultF1E1-8Main ACU faultF1E1-9Main ACU faultF1E1-AMain ACU faultF1E1-EMain ACU faultF1E1-FMain ACU faultF1E3MWO ACU internal errorF1E5Microwave inverter board communication or generation error.F1E5-1Secondary ACU faultF1E5-4Secondary ACU faultF1E5-5Secondary ACU faultF1E5-6Secondary ACU faultF1E5-7Secondary ACU faultF1E5-8Secondary ACU faultF1E5-ESecondary ACU faultF1E5-FSecondary ACU faultF1E6Microwave generation error related to door switches, MW Relay 4903, inverter, or…F1E7-0Microwave ACU over temperatureF1E7-1Microwave ACU over temperatureF1E7-2Microwave ACU over temperatureF1EA-0Main ACU over temperatureF1EA-1Main ACU over temperatureF1EA-2Main ACU over temperatureF2Over temperature sensed; over 620°F sensed by control in time of day mode or bake mode…F2E0Keypad disconnected.F2E1Stuck or shorted key on keypad.F2E1-0Stuck/shorted keyF2E1-2Stuck/shorted keyF2E2-0Keypad disconnected from HMI assemblyF2E4-0HMI over temperatureF2E4-1HMI over temperatureF2E4-2HMI over temperatureF2E5-2HMI 1 faultF2E5-4HMI 1 faultF3Shorted key detected (stuck function key on control).F3E0Main oven sensor open or shorted (open if temperature above 1112°F/600°C, shorted if…F3E0-0Main oven temp sensor open.F3E0-1Main oven temp sensor shorted.F3E1Lower main oven temperature sensor open or short-circuited.F3E1-0Secondary oven temp sensor open.F3E1-1Secondary oven temp sensor shorted.F3E2Warming drawer sensor shortedF3E3Meat probe sensor short-circuited.F3E3-0Main cavity meat probe temp sensor shorted.F3E9-0Secondary cavity meat probe temp sensor shorted.F4Shorted oven sensor detected.F4E1Microwave cavity temperature sensor error.F4E1-0Microwave cavity temperature sensor open.F4E1-1Microwave cavity temperature sensor shorted.F4E2-2Microwave magnetron temperature sensor open.F4E2-3Microwave magnetron temperature sensor shorted.F4E4Microwave oven humidity sensor error.F4E4-0Microwave humidity sensor out of range.F5Power to element relays disabled in cook mode.F5E0Door and Latch Switch do not agree (main/upper oven).F5E0-0Main door and latch switches do not agreeF5E1Latch not operating (main/upper oven)F5E1-0Main door latch motor has failed to lock.F5E1-1Main door latch motor has failed to unlock.F5E3-0Secondary door and latch switches do not agreeF5E4-0Secondary door latch motor has failed to lock.F5E4-1Secondary door latch motor has failed to unlock (double oven secondary cavity).F6Shorted meat probe alarm.F6E0User Interface / Appliance Manager communication error (requires ESAM procedure to read…F6E1Over temperature (main/upper oven). NoteF6E1-0Communication failure between Main ACU and HMIF6E2Excessive oven temperature in Clean mode.F6E2-0Communication failure between Main ACU and Secondary ACUF6E3No cavity size command programmed.F6E4User Interface / Appliance Manager (AM) state status mismatch.F6E5User interface / appliance manager mismatch.F6E6Oven Appliance ManagerF6E7-0Communication failure between Microwave ACU and HMIF7Shorted key detectedF7E5-0Main cooling fan error under speedF7E5-1Main cooling fan error over speedF7E6-0Main cooling fan blockedF7E7-0Secondary cooling fan error under speedF7E7-1Secondary cooling fan error over speedF7E8-0Secondary cooling fan blockedF8Shorted meat probe alarm.F9Door lock safety circuit on power relay board sensed.F9E0Product not wired correctly.F9E0-0Power cord miswiredF9E0-1Power cord miswiredF9E0-2Power cord miswiredF9EA-0Product under voltageF9EA-1Product over voltageFACommunication error between boards (display board side).FBCommunication error between boards (PRB side).FBE1-0Main cavity over tempFBE1-1Main cavity over temp during pyro cycleFBE3-0Secondary cavity over tempFBE3-1Secondary cavity over temp during pyro cycleFBEA-0Main cavity camera faultFBEA-1Main cavity camera faultFBEB-0Secondary cavity camera faultFBEB-1Secondary cavity camera faultFCSecond oven error sensed (double oven only).FCE1-0Model/Serial number not programmedFCE2-0Model/Serial numbers do not matchFEE6-0Main cavity bake element open circuit.FEE7-0Main cavity broil element open circuit.FEE8-0Main cavity convect 1 element open circuit.FEE9-0Main cavity convect 2 element open circuit.FEEA-0Secondary cavity bake element open circuit.FEEB-0Secondary cavity broil element open circuit.FEEC-0Secondary cavity convect 1 element open circuit.FEED-0Secondary cavity convect 2 element open circuit.FFInvalid temperature reading on power relay board.FRSecond oven error sensed (double oven only).
Get the full diagnostic procedure for any code
Step-by-step tests, expected values, wiring diagram references, and verified part numbers.
Get Started $9.95 3-day pass$29/month for all brands and Max diagnostics, with 70 Max messages a day. Plus applicable tax.