Skip to main content
Error code reference
Jenn-Air Microwave Error Codes
45 error codes documented with diagnostic procedures.
Have your model number? Get codes specific to your unit.
E11Open sensor errorE12Shorted sensor errorE13Maximum time T1 errorE61Open sensor errorE62Shorted sensor errorErr4Ambient temperature sensor value out of allowed range (shown during test mode when…Err7Humidity sensor value out of allowed range (shown during test mode when activating Meal…ERRORHumidity sensor disconnection detectedF0E0No error(s) foundF1E0Internal failureF1E1Internal failureF1E2Internal failureF1E3Internal failureF1E4Internal failureF1E5Microwave inverter board communication or operation error.F1E6Microwave generation errorF2-E0Stuck/shorted key or keypad disconnected on the control panel.F2E1Stuck or shorted key on the keypad.F2E2Internal LED error.F3-E0Main oven temperature sensor open or shorted.F3-E3Meat Probe Connector Jack or Meat Probe Shorted.F4-E1Microwave Cavity Temperature Sensor Error.F4-E4Microwave Oven Humidity Sensor Error.F4-E8Inverter Over Temperature.F4-E9Inverter and Magnetron Over Temperature.F4E2Microwave internal temperature sensor failure.F4E5Weight sensor not within normal value.F4E6Microwave wave-guide heat sensor failure.F4E7Microwave probe failure.F5E0Door and latch switch do not agree.F5E1Door latch not operating.F6-E8Lost communications with Microwave Oven Appliance Manager.F6E0Lost communication between user interface and appliance manager(s).F6E1Oven temperature error (F3E0 will also appear on display).F6E2Clean oven over temperature.F6E3Mini oven/warm drawer over temperature (not for built-in ovens).F6E4User interface / Appliance manager state status mismatch.F6E5Cavity size is incorrect.F6E6Oven appliance manager-lost communication.F8E0Low fan speed underspeedF8E1Low fan speed overspeedF8E2High fan speed underspeedF8E3High fan speed overspeedF9-E0Product not wired correctly (neutral connection switched with L1 or L2).SEA key has been short-circuited for 10 seconds or more, likely caused by stuck key(s).
Get the full diagnostic procedure for any code
Step-by-step tests, expected values, wiring diagram references, and verified part numbers.
Get Started $9.95 3-day pass$29/month for all brands and Max diagnostics, with 70 Max messages a day. Plus applicable tax.