Model reference

KitchenAid KUDC10IXBL

Dishwasher

2 documents24 error codes2 service modes

Available documentation

Tech Sheet

Kitchenaid Dishwasher KUDC10IXWH6 Tech Sheet2 pg
Covers this model

Service Flash

TECHNICAL SERVICE POINTER - KITCHENAID UNDERCOUNTER DISHWASHER Capacitive Touch User Interface (UI) Sensitivity6 pg
Covers this model

MyPros+ Max

Diagnose your KitchenAid KUDC10IXBL.

Step-by-step diagnostics from the service manual
Test values, resistance specs, and wiring references
Verified part numbers when replacement is needed

Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass

M+

M+ Max·KitchenAid Dishwasher

1-1 on my KitchenAid KUDC10IXBL

M+

Control detected K2 pilot relay stuck

From Tech Sheet W16735501, p.33:

1.Access service mode to confirm the active fault code and read stored error history.

2.Measure control board supply voltage at test points. Expected: 12 VDC and 5 VDC.

3.Inspect all connectors on the main control for corrosion or backed-out pins.

Part WPW10804018

Electronic control board

Error codes (24)

CodeMeaning

1-1Control detected K2 pilot relay stuck closed.10-1Dispenser electrical problem 10-2Vent wax motor electrical problem 10-3Drying fan motor error 2-1Control detected stuck key(s) in keypad or keypad connection.2-2Damaged or corrupted memory on control board or incompatible software…3-1Open or faulty temperature sensor, open connector or component in Temperature…3-2Shorted connection or component in Temperature Sensing Circuit, shorted or…3-3OWI (Optical Water Indicator) soil sensor failure.4-3Loose connection in Motor Circuit and/or faulty wash motor.5-1Door switch stuck open 5-2Door switch stuck closed 6-1Low/no water mechanical problem 6-2Fill valve electrical problem 6-3Too many suds detected.6-4Overfill switch stuck in 'Overfill' position and/or dishwasher not level.6-6Incoming water too cold (under 84°F / 29°C).6-7Disconnected or damaged flowmeter.6-8Water softener regeneration valve electrical problem (water softener models…7-1No heat 7-2Heater stuck on 8-1Slow drain 8-2Drain motor electrical problem 8-3Drain stuck on

Service modes (2)

Rapid Advance Mode (within Service Diagnostics)["1. Enter Service Diagnostics Cycle.","2. Press HI TEMP
Service Diagnostics Cycle["1

Full entry steps, exit procedures, and test sequences are available in Max.

Related KitchenAid dishwasher models

78,000+ service manuals · 160,000+ error codes · 55+ brands

$29/month · Cancel anytime · Or $9.95 3-day pass