mypros+
Model reference

KitchenAid KUDS30IXWH1

Dishwasher

8 documents25 error codes3 service modes

Available documentation

Tech Sheet

  • Kitchenaid Dishwasher KUDS30IXWH4 Tech Sheet2 pg
    Covers this model

Service Flash

  • TECHNICAL SERVICE POINTER - KITCHENAID UNDERCOUNTER DISHWASHER Capacitive Touch User Interface (UI) Sensitivity6 pg
    Covers this model
  • ProDry™ (with Fan Assist Operation) vs. non Fan Assist Models9 pg
    Covers this model
  • Service Pointer - W10460581 (Moisture Detected Inside Door Panels)2 pg
    Covers this model
  • Single Pvc Toe/kick Panel and Plastic Retention Clips4 pg
    Covers this model

Other

  • Service Pointer - W10756177 - Rev B (Upper Rack Disengages)6 pg
    Covers this model
  • Service Pointer - W10460578 - Rev B (Latch Blocks Door From Closing)_W104605789 pg
    Covers this model
  • W10460578B9 pg
    Covers this model
MyPros+ Max

Diagnose your KitchenAid KUDS30IXWH1.

  • Step-by-step diagnostics from the service manual
  • Test values, resistance specs, and wiring references
  • Verified part numbers when replacement is needed
Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass

Error codes (25)

CodeMeaning
1-1Pilot relay K2 detected stuck closed (on).1-2Stuck key or short circuit(s) detected in keypad or in control's input lines…10-1Dispenser electrical problem10-2Vent wax motor electrical problem10-3Drying fan error2-1Control software issue2-2Model has an LCD display and the control has been exchanged for one that is not…3-1Open temperature sensing circuit3-2Shorted temperature sensing circuit3-3OWI (Optical Water Indicator) failed calibration.4-3Wash motor not running.5-1Door stuck open5-2Door stuck closed6-1Low or no water6-2Fill valve electrical problem.6-3Suds or air detected in wash pump.6-4Float switch open (overfill condition detected)6-6Cool incoming water6-7Flow meter problem6-8Water softener regeneration valve electrical problem (water softener models…7-1No heat7-2Heater stuck on8-1Slow drain8-2Drain motor electrical problem8-3Drain stuck on

Service modes (3)

  • Rapid Advance Mode (during customer cycle)Press HI TEMP
  • Sales Demo Mode ExitRun Service Diagnostics Cycle to clear Demo mode.
  • Service Diagnostics CycleWhile in standby mode, press any 3 keys in the sequence 1-2-3-1-2-3-1-2-3 with no more than 1…

Full entry steps, exit procedures, and test sequences are available in Max.

Related KitchenAid dishwasher models

78,000+ service manuals · 160,000+ error codes · 55+ brands

Get Started

$29/month · Cancel anytime · Or $9.95 3-day pass