Model reference

Maytag MVWB725BG0

Name: Maytag MVWB725BG0
Brand: Maytag

Washer

5 documents24 error codes8 service modes

Available documentation

Training Pointer - Replacement Bearing Procedure for Top Load, Direct Drive Washers16 pg
Covers this model

MyPros+ Max

$29/month · Cancel anytime · Or $9.95 3-day pass

M+

M+ Max·Maytag Washer

dL on my Maytag MVWB725BG0

M+

Lid Lock Failure - lid not closed

From Tech Sheet W14252398, p.50:

1.Access service mode to confirm the active fault code and read stored error history.

2.Measure door lock assembly resistance across PTC terminals. Expected: ~200 ohms cold.

3.Inspect strike and latch alignment. A misaligned strike prevents the switch stack from closing.

Part W10810403

Door lock assembly

Automatic Diagnostic Test1
Automatic Diagnostic Test Mode1. Washer must be in standby mode (plugged in, all indicators off) or setting mode (plugged in…
Console and Indicators Diagnostic Test1. Plug in washer or reconnect power. 2. From Standby or Setting mode, press and release the…
Console and Indicators Diagnostic Test Mode1. Plug in washer or reconnect power. 2. From Standby or Setting mode, press and release within 4…
Factory Defaults Reset1
Manual Diagnostic Test1
Manual Diagnostic Test Mode1
Pressure Transducer Calibration1

Full entry steps, exit procedures, and test sequences are available in Max.

78,000+ service manuals · 160,000+ error codes · 55+ brands

$29/month · Cancel anytime · Or $9.95 3-day pass