mypros+
Model reference

Maytag MVWB955F

Washer

1 document36 error codes7 service modes

Available documentation

Service Manual

  • Service Manual Whirlpool & Maytag 6.2 CU FT Direct Drive Top Load Washer68 pg
    Covers this model
MyPros+ Max

Diagnose your Maytag MVWB955F.

  • Step-by-step diagnostics from the service manual
  • Test values, resistance specs, and wiring references
  • Verified part numbers when replacement is needed
Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass

Error codes (36)

CodeMeaning
F0E2Oversuds condition detectedF0E3Overload detectedF0E4Spin limited by water temperatureF0E5Off balance load condition detected (displayed as 'OFB').F1E1Main control fault detected.F1E2Motor control section of the main control has faulted.F2E1User interface is detecting a button is continuously activated (stuck button).F2E3Machine control or user interface ID do not match expected values (UI mismatch).F2E4UI software errorF2E5UI software errorF3E1Pressure system faultF3E2Inlet water temperature faultF3E4Bulk dispense faultF4E1Heater stuck onF4E2Heater not turning onF5E1Lid switch faultF5E2Lid lock will not lock or lid lock failureF5E3Lid lock will not unlockF5E4Lid not opened between cyclesF6E2Communication errorF6E3Communication errorF7E0Loss of powerF7E1Loss of power during spinF7E2Motor drive module over temperature detected.F7E3Motor drive module over current detected.F7E4Motor drive module over voltage detected.F7E5Shifter failureF7E6Motor circuit openF7E7Motor start failureF7E8Motor stator over temperature
View all 36 error codes
F7E9Locked rotorF8E1Long fillF8E3Overflow or flood conditionF8E6Water hazardF9E1Drain pump system problemF9E2Water ring detected, pump drive system problem

Service modes (7)

  • Fault Code Display / Clearing["Enter Service Diagnostic Mode.","If saved fault codes exist, the most recent code will flash in…
  • Key Activation & Encoder Test["First activate Service Diagnostic Mode.","Press and release the 1st button used to activate…
  • Load Size Calibration Cycle["Enter Service Diagnostic Mode.","Enter Service Test Mode.","Select function number 052.","Press…
  • Service Diagnostic Mode["Ensure washer is in standby mode (plugged in with all indicators off).","Select any three (3)…
  • Service Diagnostics Verification Cycle["Enter Service Diagnostic Mode.","Enter Service Test Mode.","Select function number 051.","Press…
  • Service Test Mode["First activate Service Diagnostic Mode.","Press and release the 2nd button used to activate…
  • Software Version Display["Activate Service Diagnostic Mode.","Press and hold the 2nd button used to activate the Service…

Full entry steps, exit procedures, and test sequences are available in Max.

Related Maytag washer models

78,000+ service manuals · 160,000+ error codes · 55+ brands

Get Started

$29/month · Cancel anytime · Or $9.95 3-day pass