Model reference

Whirlpool W11266095A

Dishwasher

1 document32 error codes1 service mode

Available documentation

Tech Sheet

Tech Sheet - Appliance Service Document16 pg
Covers this model

MyPros+ Max

Diagnose your Whirlpool W11266095A.

Step-by-step diagnostics from the service manual
Test values, resistance specs, and wiring references
Verified part numbers when replacement is needed

Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass

M+

M+ Max·Whirlpool Dishwasher

1-1 on my Whirlpool W11266095A

M+

Control detected K400 pilot relay stuck

From Tech Sheet W17628440, p.12:

1.Access service mode to confirm the active fault code and read stored error history.

2.Measure control board supply voltage at test points. Expected: 12 VDC and 5 VDC.

3.Inspect all connectors on the main control for corrosion or backed-out pins.

Part WPW10804018

Electronic control board

Error codes (32)

CodeMeaning

1-1Control detected K400 pilot relay stuck closed.1-2Control software issue 10-1Dispenser electrical problem 10-2Vent wax motor electrical problem 10-3Drying fan error 12-1No communication between ECM and control 12-2No link between ECM and wireless router 12-3No link between ECM and Internet 12-5Antenna B problem 12-7Provisioning problem 2-1Control detected stuck key(s) in keypad or keypad connection.2-2No response from UI 3-1Open connector or component in Temperature Sensing circuit; open or faulty…3-2Shorted connection or component in Temperature Sensing circuit; incoming water…3-3OWI calibration failure or drain hose check valve not sealing.4-4Wash motor failure 5-1Door stuck open 5-2Door stuck closed 6-1Low/no water (mechanical problem)6-2Fill valve electrical problem 6-3Suds/air in pump 6-4Float switch open 6-7Flowmeter disconnected or damaged.6-8Water softener regeneration valve electrical problem 7-1No heat 7-2Heater stuck on 8-4Drain motor electrical problem 9-1Diverter can't find position 9-2Diverter stuck on 9-3Diverter disc missing

View all 32 error codes

9-4Lower spray arm error F9E4Lower spray arm motor/sensor error detected at end of service diagnostics cycle.

Service modes (1)

Service Diagnostics Cycle1

Full entry steps, exit procedures, and test sequences are available in Max.

Related Whirlpool dishwasher models

78,000+ service manuals · 160,000+ error codes · 55+ brands

$29/month · Cancel anytime · Or $9.95 3-day pass