mypros+
Model reference

Whirlpool GFE461LVB1

Range

3 documents25 error codes15 service modes

Available documentation

Tech Sheet

  • Tech Sheet - W10435364 - Rev A_W104353648 pg
    Covers this model

Service Manual

  • Troubleshooting Gas and Electric Freestanding Range Electronic Controls70 pg
    Covers this model

Installation Guide

  • Installation Instructions16 pg
    Covers this model
MyPros+ Max

Diagnose your Whirlpool GFE461LVB1.

  • Step-by-step diagnostics from the service manual
  • Test values, resistance specs, and wiring references
  • Verified part numbers when replacement is needed
Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass

Error codes (25)

CodeMeaning
F1Control failure or UL A/D error(s) detected in the control board.F1 E*Control board failure (all F1 sub-codes indicate control fault).F1-E0EEPROM communication error.F1-E5Sensor out of range.F1-E7PCB thermistor open or shorted.F2Shorted/stuck key detected on the control keypad.F2-E0Keypad disconnected.F2-E1Stuck key.F2-E2Cancel key error.F3Oven sensor opened or oven sensor shorted.F3 E0Oven temperature sensor fault (open or shorted)F3 E1Lower oven temperature sensor fault (MRC II double oven models).F3 E2Warming drawer temperature sensor fault.F3-E0Main oven sensor open or shorted.F3-E2Warming drawer sensor open or shorted.F5 E0Door position switch faultF5 E1Door latch switch/system faultF5 E2Door switch fault.F5-E0Door and switches do not agree (Clean mode).F5-E1Door latch not operating (Clean mode).F6 E*Control communication failure.F6-E1Over temperature during cook mode.F6-E2Over temperature during clean mode.F6-E3Over temperature (warming drawer).F9House miswired

Service modes (15)

  • Diagnostics Mode (Auto Test)1
  • DISPLAYPress CANCEL > CANCEL > START to enter Service Mode
  • ENG MODEPress CANCEL > CANCEL > START to enter Service Mode
  • FAULTSPress CANCEL > CANCEL > START to enter Service Mode
  • LCC Diagnostic Mode (LCC90/LCC95/LCC180)["Press CANCEL, CANCEL, START in sequence.","Press TEMP/TIME '+' key to cycle through diagnostic…
  • LCC190 Diagnostic Mode (Self Clean, Convection models)["Press CANCEL, CANCEL, START in sequence.","Press TEMP/TIME or TEMP/HOUR '+' key to cycle through…
  • MRC Diagnostic Mode["Press CANCEL, CANCEL, START in sequence.","Press TEMP/TIME '+' key to cycle through diagnostic…
  • MRC Diagnostic Mode (Fan/True Convection Electric - Oven Light entry)["Press CANCEL, CANCEL, START in sequence.","Press TEMP/TIME '+' key to cycle through diagnostic…
  • MRC II Diagnostic Mode (Number 3 key entry - KitchenAid models)["Press OFF/OFF/START or CANCEL/CANCEL/START in sequence.","Press the number '3' key to cycle…
  • MRC II Diagnostic Mode (TEMP/TIME entry)["Press CANCEL, CANCEL, START in sequence.","Press TEMP/TIME '+' keypad to cycle through diagnostic…
  • Temperature Adjustment1
  • TEST MODEPress CANCEL > CANCEL > START to enter Service Mode
  • TEST ON (Relay Checks)Press CANCEL > CANCEL > START to enter Service Mode. Upon entry, 'TEST ON' is displayed. Press the…
  • USAGEPress CANCEL > CANCEL > START to enter Service Mode
  • VERSIONPress CANCEL > CANCEL > START to enter Service Mode

Full entry steps, exit procedures, and test sequences are available in Max.

Related Whirlpool range models

78,000+ service manuals · 160,000+ error codes · 55+ brands

Get Started

$29/month · Cancel anytime · Or $9.95 3-day pass