Model reference

Whirlpool GY398LXPQ00

Range

8 documents24 error codes3 service modes

Available documentation

Tech Sheet

tech sheet 9759903 reva8 pg
Covers this model
TECH SHEET8 pg
Covers this model
Whirlpool Range YGY398LXPQ00 Tech Sheet 97599038 pg
Covers this model
Tech Sheet - 97613898 pg
Covers this model
Whirlpool Range YGY398LXPQ04 Tech Sheet 97613898 pg
Covers this model

Service Manual

FAILURE CODES AND WIRING DIAGRAMS for WHIRLPOOL AND KITCHENAID SLIDE-IN & FREESTANDING GAS & ELECTRIC RANGES80 pg
Covers this model

Bulletin

Service Pointer - 8178569 - Control Panel Scratched2 pg
Covers this model

Service Flash

Service Pointer - 8178664 - Control Not Responding2 pg
Covers this model

MyPros+ Max

Diagnose your Whirlpool GY398LXPQ00.

Step-by-step diagnostics from the service manual
Test values, resistance specs, and wiring references
Verified part numbers when replacement is needed

Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass

M+

M+ Max·Whirlpool Range

F1-E0 on my Whirlpool GY398LXPQ00

M+

EEPROM communications error.

From Tech Sheet W18556448, p.20:

1.Access service mode to confirm the active fault code and read stored error history.

2.Measure control board supply voltage at test points. Expected: 12 VDC and 5 VDC.

3.Inspect all connectors on the main control for corrosion or backed-out pins.

Part WPW10804018

Electronic control board

Error codes (24)

CodeMeaning

F1-E0EEPROM communications error.F1-E1EEPROM checksum failure.F1-E2UL A/D error(s).F1E0EEPROM communications error.F1E1EEPROM checksum failure.F1E2UL A/D error(s).F2-E0Shorted key detected on control panel.F2-E1Keytail (membrane tail) unplugged from control.F2E0Shorted key.F2E1Keytail unplugged.F3-E0Oven temperature sensor circuit is open.F3-E1Oven temperature sensor is shorted.F3-E2BAKE/BROIL range over temperature condition detected.F3-E3CLEAN range over temperature condition detected.F3E0Oven sensor opened (open circuit).F3E1Oven sensor shorted.F3E2BAKE/BROIL range over temperature.F3E3CLEAN range over temperature.F5-E0Door and switches do not agree (door position mismatch).F5-E1Latch error during CLEAN F5-E2Latch error during CLEAN cycle.F5E0Door and switches do not agree.F5E1Door latch not operating.F5E2Latch error during CLEAN cycle.

Service modes (3)

Hidden EOC FunctionsPress and hold the appropriate key for 5 seconds to activate the desired hidden function. Keys
Recall Last Failure CodePress and hold CANCEL/OFF key for 5 seconds until last error code is displayed.
Temperature Calibration Adjustment1. Press and hold BAKE pad for 5 seconds. Current offset is shown in 3-digit display; CAL is shown…

Full entry steps, exit procedures, and test sequences are available in Max.

Related Whirlpool range models

78,000+ service manuals · 160,000+ error codes · 55+ brands

$29/month · Cancel anytime · Or $9.95 3-day pass