Model reference
Whirlpool SF378LEPS3
Range
9 documents20 error codes1 service mode
Available documentation
Service Manual
- Whirlpool Gas Range Direct Spark Ignition System29 pg
- Job Aid - 30″ Freestanding Self-Cleaning Gas Range68 pg
- 30″ Freestanding Self-Cleaning Gas Range68 pg
- Whirlpool Gas Range Direct Spark Ignition System KR-2829 pg
Service Flash
- Service Pointer - 8178185 - Rev A Ignition Problems2 pg
- Service Pointer - 8178446 - PF Error Code Appears All the Time2 pg
Installation Guide
- Installation Instructions32 pg
- Instruction Sheet2 pg
Other
- 81781852 pg
MyPros+ Max
Diagnose your Whirlpool SF378LEPS3.
- Step-by-step diagnostics from the service manual
- Test values, resistance specs, and wiring references
- Verified part numbers when replacement is needed
Start diagnosing
$29/month · Cancel anytime · Or $9.95 3-day pass
Error codes (20)
CodeMeaning
F0 E0Factory defaultF1 E0EEPROM communications error.F1 E1EEPROM checksum error.F1 E2UL A/D error(s).F1 E4Model ID error.F1 E6Latch signal mismatch error.F2 E0Shorted key.F2 E1Key tail unplugged.F3 E0Oven sensor openedF3 E1Oven sensor shortedF3 E2Bake range over temperature.F3 E3Clean range over temperature.F3 E4Oven sensor openedF3 E5Oven sensor shortedF3 E6Warming drawer sensor open.F3 E7Warming drawer sensor shorted.F5 E0Door switches do not agree.F5 E1Door latch not operating.F8 E0N/A (no likely failure condition described).PFA reset has occurred in the Electronic Range Control (ERC), typically caused by…Service modes (1)
- Last Error Code RecallPress and hold the CANCEL/OFF key for 5 seconds until the last error code is displayed.
Full entry steps, exit procedures, and test sequences are available in Max.
Related Whirlpool range models
78,000+ service manuals · 160,000+ error codes · 55+ brands
Get Started$29/month · Cancel anytime · Or $9.95 3-day pass