Model reference

Whirlpool SF385PEGW6

Range

8 documents24 error codes4 service modes

Available documentation

Tech Sheet

TECH SHEET - 8272223 - Rev B4 pg
Covers this model
Whirlpool Range SF387LEGT7 Tech Sheet4 pg
Covers this model
Whirlpool Range SF387LEGQ1 SF387LEGZ0 Tech Sheet4 pg
Covers this model
Supplemental Tech Sheet for Flame Sense Power Circuit1 pg
Covers this model

Service Manual

Failure Codes and Wiring Diagrams for Freestanding Gas & Electric Ranges64 pg
Covers this model

Service Flash

Technical Service Pointer - Gas Freestanding Ranges with Direct Spark Ignition (DSI) Control18 pg
Covers this model

Installation Guide

Installation Instructions9 pg
Covers this model

Other

43222541 pg
Covers this model

MyPros+ Max

Diagnose your Whirlpool SF385PEGW6.

Step-by-step diagnostics from the service manual
Test values, resistance specs, and wiring references
Verified part numbers when replacement is needed

Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass

M+

M+ Max·Whirlpool Range

F1 E0 on my Whirlpool SF385PEGW6

M+

EEPROM communications failure.

From Tech Sheet W16436159, p.51:

1.Access service mode to confirm the active fault code and read stored error history.

2.Measure control board supply voltage at test points. Expected: 12 VDC and 5 VDC.

3.Inspect all connectors on the main control for corrosion or backed-out pins.

Part WPW10804018

Electronic control board

Error codes (24)

CodeMeaning

F1 E0EEPROM communications failure.F1 E1EEPROM checksum failure.F1 E2UL A/D error(s).F1E0EEPROM communications error.F1E1EEPROM checksum failure.F1E2UL A/D error(s).F2 E0Shorted key on control panel.F2 E1Key tail unplugged from control.F2E0Shorted key on the control panel.F2E1Key tail unplugged from control.F3 E0Oven temperature sensor circuit is open.F3 E1Oven temperature sensor circuit is shorted.F3 E2Bake range over temperature condition.F3 E3Clean range over temperature condition.F3E0Oven temperature sensor opened (open circuit).F3E1Oven temperature sensor shorted.F3E2Bake range over temperature condition.F3E3Clean range over temperature condition.F5 E0Door switch and latch switch do not agree (conflicting states).F5 E1Latch motor not operating or latch switch failure.F5 E2Door latch error during Clean cycle.F5E0Door switch and latch switch do not agree (conflicting states).F5E1Latch solenoid/motor not operating or latch switch failure.F5E2Latch during clean cycle error.

Service modes (4)

F5 Failure Code ClearAfter correcting the F5 fault condition, reconnect power to control
Last Error Code RecallPress and hold CANCEL/OFF key for 5 seconds until last error code is displayed.
Temperature Adjustment (Calibration)Press and hold BAKE pad for 5 seconds
Temperature Calibration AdjustmentPress and hold BAKE pad for 5 seconds

Full entry steps, exit procedures, and test sequences are available in Max.

Related Whirlpool range models

78,000+ service manuals · 160,000+ error codes · 55+ brands

$29/month · Cancel anytime · Or $9.95 3-day pass