Model reference

Whirlpool WERC4101SB0

Range

6 documents26 error codes2 service modes

Available documentation

Tech Sheet

Fiche Technique – Ne Pas Jeter6 pg
Covers this model
Fiche Technique – Ne Pas Jeter6 pg
Covers this model
TECH SHEET - W10116304 - Rev B6 pg
Covers this model
TECH SHEET - W10134197 - Rev B6 pg
Covers this model
Tech Sheet - 9762991 - Rev A_97629916 pg
Covers this model

Installation Guide

Installation Instructions16 pg
Covers this model

MyPros+ Max

Diagnose your Whirlpool WERC4101SB0.

Step-by-step diagnostics from the service manual
Test values, resistance specs, and wiring references
Verified part numbers when replacement is needed

Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass

M+

M+ Max·Whirlpool Range

E0 F1 on my Whirlpool WERC4101SB0

M+

EEPROM checksum failure.

From Tech Sheet W13734441, p.13:

1.Access service mode to confirm the active fault code and read stored error history.

2.Measure control board supply voltage at test points. Expected: 12 VDC and 5 VDC.

3.Inspect all connectors on the main control for corrosion or backed-out pins.

Part WPW10804018

Electronic control board

Error codes (26)

CodeMeaning

E0 F1EEPROM checksum failure.E0 F2Shorted key detected.E0 F3Oven sensor opened.E0 F5Door and switches do not agree.E1 F1UL A/D error(s).E1 F3Oven sensor shorted.E1 F5Door latch not operating.E2 F1EEPROM communications error.E2 F3BAKE/BROIL range over temperature.E2 F5Latch error during CLEAN.E3 F3CLEAN range over temperature.F1EEPROM checksum failure or UL A/D error(s).F1-E0EEPROM checksum failure.F1-E1UL A/D error(s).F2EEPROM communications error or shorted key detected.F2-E0Shorted key detected.F2-E1EEPROM communications error.F3Oven sensor opened, oven sensor shorted, BAKE/BROIL range over temperature, or…F3-E0Oven sensor opened.F3-E1Oven sensor shorted.F3-E2BAKE/BROIL range over temperature.F3-E3CLEAN range over temperature.F5Door and switches do not agree, door latch not operating, or latch error during…F5-E0Door and switches do not agree.F5-E1Door latch not operating.F5-E2Latch error during CLEAN.

Service modes (2)

Diagnostics ModeWith the oven not in cooking, broiling, or cleaning mode, press Cancel/OFF, Cancel/OFF, START. The…
Temperature Adjustment ModePress and hold BAKE key for 5 seconds

Full entry steps, exit procedures, and test sequences are available in Max.

Related Whirlpool range models

78,000+ service manuals · 160,000+ error codes · 55+ brands

$29/month · Cancel anytime · Or $9.95 3-day pass