Model reference

Whirlpool WFG775H0HZ2

Range

7 documents19 error codes5 service modes

Available documentation

Tech Sheet

Wiring Diagram - W11326977 - Rev A2 pg
Covers this model
Tech Sheet36 pg
Covers this model
Tech Sheet36 pg
Covers this model
Tech Sheet - W10538796 - Rev A (FR)8 pg
Covers this model
Tech Sheet W10538795 Rev A8 pg
Covers this model

Service Manual

Technical Manual - Cooking Surface Temperature Limits12 pg
Covers this model

Quick Reference

Quick Start Guide2 pg
Covers this model

MyPros+ Max

Diagnose your Whirlpool WFG775H0HZ2.

Step-by-step diagnostics from the service manual
Test values, resistance specs, and wiring references
Verified part numbers when replacement is needed

Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass

M+

M+ Max·Whirlpool Range

F1 on my Whirlpool WFG775H0HZ2

M+

Internal circuit board failure or A/D

From Tech Sheet W17820338, p.30:

1.Access service mode to confirm the active fault code and read stored error history.

2.Measure control board supply voltage at test points. Expected: 12 VDC and 5 VDC.

3.Inspect all connectors on the main control for corrosion or backed-out pins.

Part WPW10804018

Electronic control board

Error codes (19)

CodeMeaning

F1Internal circuit board failure or A/D error(s) (displayed as F1E0, F1E1, F1E2…F1E0Internal board failure.F1E1Internal board failure / A/D error(s).F1E2Internal board failure / A/D error(s).F2Shorted key (keypad short circuit) (displayed as F2E0 on LCC 180/190 displays).F2E0Shorted key detected (LCC 180/190 control).F2E1Shorted keypad.F3Oven sensor open circuit (displayed as F3E0 on LCC 180/190)F3E0Oven sensor opened, oven sensor shorted, bake/broil range over temperature, or…F3E1Oven sensor opened.F3E2Oven sensor shorted.F3E3Bake/Broil range over temperature.F3E4Clean range over temperature.F5Door and latch switch mismatch during clean mode (displayed as F5E0, F5E2 on…F5E0Door and switches do not agree (Clean mode).F5E1Door latch not operating (Clean mode) (LCC 180/190 control).F5E2Door and door position switches do not agree (Clean mode) (LCC 180/190 control).F6E1Oven over temperature when heating.F9E0Miswired house or miswired range.

Service modes (5)

Diagnostic ModePress CANCEL > CANCEL > START within 5 seconds.
Diagnostic Test Mode (Relay Tests)From within Diagnostic Mode, the initial display shows 'tSt' (LCC 90/95) or 'tESt' (LCC 180/190)…
Diagnostics modePress CANCEL > CANCEL > START within a 5-second period.
Diagnostics Test Mode (Relay Checks)While in Diagnostics mode, press individual keypads to test control relays
Temperature Adjustment1

Full entry steps, exit procedures, and test sequences are available in Max.

Related Whirlpool range models

78,000+ service manuals · 160,000+ error codes · 55+ brands

$29/month · Cancel anytime · Or $9.95 3-day pass