mypros+
Model reference

Whirlpool YWFE361LVB1

Range

6 documents17 error codes5 service modes

Available documentation

Tech Sheet

  • Fiche technique - Tech Sheet W103844608 pg
    Covers this model
  • Tech Sheet - W10384454 - Rev A8 pg
    Covers this model
  • Tech Sheet - W10434980 - Rev A (FR)8 pg
    Covers this model

Service Flash

  • Technical Service Pointer - W10412840 (Passive Door Hinge Design)6 pg
    Covers this model
  • Technical Service Pointer - W10473748 (F9 E0 Error Code)6 pg
    Covers this model

Installation Guide

  • Installation Instructions16 pg
    Covers this model
MyPros+ Max

Diagnose your Whirlpool YWFE361LVB1.

  • Step-by-step diagnostics from the service manual
  • Test values, resistance specs, and wiring references
  • Verified part numbers when replacement is needed
Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass

Error codes (17)

CodeMeaning
F1Internal circuit board failure or A/D error(s)F1E0Internal circuit board failure (LCC 180/190 display).F1E1Internal circuit board failureF1E2Internal circuit board failureF2Shorted key on control panel (LCC 90/95 display).F2E0Shorted key on control panel (LCC 180/190 display).F3Oven sensor open circuit, oven sensor short circuit, bake/broil excessive…F3E0Oven sensor open circuit (LCC 180/190 display).F3E1Oven sensor short circuit (LCC 180/190 display).F3E2Bake/Broil excessive temperature (LCC 180/190 display).F3E3Clean mode excessive temperature (LCC 180/190 display).F5Door and switch mismatch during clean mode, or door latch not functioning…F5E0Door and switch mismatch during clean mode (LCC 180/190 display).F5E1Door latch not functioning during clean mode (LCC 180/190 display).F5E2Door and switch mismatch during clean mode (LCC 180/190 display).F9Defective housing wiring or defective range wiring (LCC 90/95 display).F9E0Defective housing wiring or defective range wiring (LCC 180/190 display).

Service modes (5)

  • diagnosticPress CANCEL > CANCEL > START within 5 seconds.
  • diagnostic_test_modeWhile in diagnostic mode, press the following buttons to test individual relays
  • Diagnostics ModePress CANCEL > CANCEL > START within a 5-second period.
  • Diagnostics Test Mode (Relay Checks)While in Diagnostics Mode, press individual keypads to test control relays
  • Temperature Adjustment ModeStep 1

Full entry steps, exit procedures, and test sequences are available in Max.

Related Whirlpool range models

78,000+ service manuals · 160,000+ error codes · 55+ brands

Get Started

$29/month · Cancel anytime · Or $9.95 3-day pass