mypros+
Model reference

Whirlpool W10071740B

Washer

3 documents27 error codes6 service modes

Available documentation

Tech Sheet

  • Technical Service Sheet16 pg
    Covers this model
  • Kenmore Washer Technical Service Sheet16 pg
    Covers this model
  • Whirlpool Kenmore Washer Tech Sheet16 pg
    Covers this model
MyPros+ Max

Diagnose your Whirlpool W10071740B.

  • Step-by-step diagnostics from the service manual
  • Test values, resistance specs, and wiring references
  • Verified part numbers when replacement is needed
Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass

Error codes (27)

CodeMeaning
F0Load detected in drum at start of CLEAN WASHER cycle (detection by weight).F1Water temperature sensor (NTC) value is out of range (23°F to 217°F / -5°C to…F10Water heater errorF11Water temperature sensor (NTC) errorF15MCU thermal trip errorF2Motor Control Unit (MCU) has internal failure; if failure occurs during…F20Pump drive system errorF21Long drainF22Pump drive system error (alternate code)F24Load detected in drum at start of Clean Washer cycle (detection by weight).F26Door lock errorF27Overflow conditionF28Serial communication errorF29Door unlock errorF3Overflow conditionF30Dispenser system errorF31MCU temperature errorF33Pump drive system errorF34Pump drive system error (alternate display)F35Load detected in drum at start of CLEANING WASHER cycle (detection by weight).F4Dispenser system errorF5Pump driver fails to activate, one of the main relays is not working properly…F6Motor speed sensing errorF7Serial communication errorF8No water detected entering machine or pressure switch trip not detected…F9Door switch errorSdSuds lock

Service modes (6)

  • Manual Diagnostic Test["Ensure washer is empty and control is in OFF state.","Close the door.","Select any one key…
  • Quick Diagnostic Test (bypassing Service History)["Ensure drum is empty.","Close the door.","Push POWER.","Select the CLEAN WASHER cycle.","Press…
  • Quick Entry Diagnostic Test (bypasses error history)["Ensure drum is empty.","Close the door.","Push POWER.","Select the CLEAN WASHER cycle.","Press…
  • Quick Entry Diagnostic Test (bypassing Service History)["Execute with an empty drum.","Close the door.","Push POWER.","Select the CLEAN WASHER…
  • Service History Mode & Diagnostic Test["Ensure washer is empty and control is in OFF state.","Close the door.","Select any one key…
  • Service History Mode & Diagnostic Test (Universal Entry)["Washer must be empty and control must be in the OFF state.","Close the door.","Select any one key…

Full entry steps, exit procedures, and test sequences are available in Max.

Related Whirlpool washer models

78,000+ service manuals · 160,000+ error codes · 55+ brands

Get Started

$29/month · Cancel anytime · Or $9.95 3-day pass