mypros+
Model reference

Whirlpool W11466159B

Washer

1 document34 error codes5 service modes

Available documentation

Tech Sheet

  • Tech Sheet W11466159B2 pg
    Covers this model
MyPros+ Max

Diagnose your Whirlpool W11466159B.

  • Step-by-step diagnostics from the service manual
  • Test values, resistance specs, and wiring references
  • Verified part numbers when replacement is needed
Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass

Error codes (34)

CodeMeaning
F0E2Oversuds condition detected.F0E3Overload condition detected.F0E4Spin limited by water temperature.F0E5Off balance load detected.F0E7Load detected when running Clean Washer cycle.F0E8Water ring condition.F0E9Off balance pause.F1E1Main Control (ACU) fault.F1E2Motor drive module over voltage.F2E1UI stuck button.F2E2UI disconnected.F2E3ACU/UI mismatch.F3E2Pressure system fault.F3E3Inlet water temperature fault.F5E1Lid switch faultF5E3Lid will not lock or unlock.F5E4Lid not opened between cycles.F6E1Communication errorF6E3Communication errorF7E1Tachometer missing or wrong signal.F7E2MCI drive failure.F7E3Basket engaged during wash.F7E4Basket re-engagement failure.F7E6Motor circuit open.F7E7Motor unable to reach target RPM.F7E8Motor drive module over temperature.F7E9Locked rotor.F7EAMotor phase loss.F7ECMotor drive module over current/overload.F8E1Long fill condition.
View all 34 error codes
F8E3Overflow or flood condition.F8E6Water hazard.F9E1Long drain fault.F9E9Wrong voltage.

Service modes (5)

  • Automatic TestFrom Service Mode
  • Fault HistoryFrom Service Mode
  • Service Mode Entry1. Ensure washer is in standby mode (plugged in with all LEDs off). 2. Using E3 cycle selection…
  • Software VersionFrom Service Mode
  • UI TestFrom Service Mode

Full entry steps, exit procedures, and test sequences are available in Max.

Related Whirlpool washer models

78,000+ service manuals · 160,000+ error codes · 55+ brands

Get Started

$29/month · Cancel anytime · Or $9.95 3-day pass