mypros+
Model reference

Whirlpool WFW94HEAC2

Washer

12 documents30 error codes9 service modes

Available documentation

Tech Sheet

  • Whirlpool WFW87HEDW0 Washer Tech Sheet W10602465 Rev B48 pg
    Covers this model
  • For Service Technician's Use Only48 pg
    Covers this model
  • Whirlpool FL Washer WFW72HEDW Tech Sheet48 pg
    Covers this model

Service Manual

  • JobAidW10372167L8586 pg
    Covers this model
  • Direct Drive FL Washer86 pg
    Covers this model

Service Flash

  • Technical Service Pointer - W10600534 (Dispenser Drawer)3 pg
    Covers this model
  • TECHNICAL SERVICE POINTER - Front-Load, Direct Drive Washers (ALPHA) Potential Internal Hose Leak3 pg
    Covers this model
  • TECHNICAL SERVICE POINTER - Whirlpool and Maytag Direct Drive Front Load Washers Intermittent Door Lock Operation2 pg
    Covers this model
  • Technical Service Pointer - Drain Pump Assembly Relocation6 pg
    Covers this model
  • TECHNICAL SERVICE POINTER - F1E1 Error Code with Stacked Long-Vent Dryer6 pg
    Covers this model

Training

  • Training Pointer W10642118 Changes in Hardware and Diagnostics21 pg
    Covers this model

Installation Guide

  • Installation Instructions20 pg
    Covers this model
MyPros+ Max

Diagnose your Whirlpool WFW94HEAC2.

  • Step-by-step diagnostics from the service manual
  • Test values, resistance specs, and wiring references
  • Verified part numbers when replacement is needed
Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass

Error codes (30)

CodeMeaning
dLDoor lock error (saved as F5E2)dUDoor unlock error (saved as F5E3)F0E1Load detected during the washer cleaning cycleF1E1ACU errorF1E2Motor control errorF2E3Unsupported cycleF3E1Water level system errorF3E2Temperature system errorF4E0Heater is not detectedF5E1Door switch errorF5E2Door lock errorF5E3Door unlock errorF5E4Door not opened between cyclesF6E1Communication error between CCU and MCUF6E2Communication error UI to ACUF6E3Communication error ACU to UIF7E1Drive motor tachometer error / washer overloadF7E2Motor drive circuit over temperatureF7E8Motor over temperatureF8E0Steam inlet valve error (not available on all models)F8E1No water detected entering washer or pressure switch trip not detectedF8E2Dispenser system errorF8E3Overflow conditionF8E4Flow meter faultF9E1Long drainIntInterruptedLo FLNo water detected entering washer or water level sensor trip not detected…rLLoad detected during the washer cleaning cycle (remove load)SdSuds detected (alternate display)SudSuds detected

Service modes (9)

  • Clear Fault Codes1
  • Fault Code DisplayFrom Service Diagnostic Mode, press and release the 3rd button used to activate Service Diagnostic…
  • Fault Code Display / Advance1
  • Fault/Error Code DisplayFrom Service Diagnostic mode, press and release the 3rd button used to activate Service Diagnostic…
  • Quick Diagnostic TestFrom Service Diagnostic mode, press and release the 2nd button used to activate Service Diagnostic…
  • Quick Diagnostics1
  • Service Diagnostic Mode1. Washer must be in standby mode (plugged in, all indicators off). 2. Wait 30 seconds after…
  • Software Version DisplayFrom Service Diagnostic mode, press and hold the 2nd button used to activate Service Diagnostic…
  • User Interface TestFrom Service Diagnostic mode, press and release the 1st button used to activate Service Diagnostic…

Full entry steps, exit procedures, and test sequences are available in Max.

Related Whirlpool washer models

78,000+ service manuals · 160,000+ error codes · 55+ brands

Get Started

$29/month · Cancel anytime · Or $9.95 3-day pass