Fisher & Paykel Washer, Dishwasher, Oven Error Codes

18 error codes for Fisher & Paykel washer, dishwasher, oven models. Each links to the full diagnostic procedure from the service manual.

CodeDescription

1Motor controller fault 2Motor controller fault 3Motor controller fault 37Blocked pump error 41Temperature sensor fault 43Out of balance switch fault 49Faulty cold water valve 51Diverter fault 52Diverter fault 6Motor controller fault 7Display board fault 9Size error F1Temperature around electronics exceeded 185°F / 85°C F2Oven temperature exceeded maximum allowable during clean cycle F3Oven temperature exceeded 600°F during bake cycle F4Oven controller board fault F5Communication error between clock module and oven controller board F7Oven door lock fault

MyPros+ Max

Get the full diagnostic procedure for any Fisher & Paykel washer, dishwasher, oven error code.

Step-by-step tests with expected resistance, voltage, and continuity values
Wiring diagram references and connector pinouts
Verified part numbers when replacement is required

Get started

$29/month · Cancel anytime · Or $9.95 3-day pass

M+

M+ Max·Fisher & Paykel Washer, Dishwasher, Oven

1 on my Fisher & Paykel Washer, Dishwasher, Oven

M+

Motor controller fault

From Service Manual 240132, p.24:

1.Access service mode to confirm the active fault code and read stored error history.

2.Measure the drive motor winding resistance at the main control connector. Expected: 2 to 6 ohms between winding pairs.

3.Rotate the drum by hand and check for free rotation. Inspect the belt and pulley for glaze or wear; a slipping belt mimics a motor fault under load.

Part W10006384

Drive motor

Start diagnosing faster today.

$29/month · Cancel anytime · Or $9.95 3-day pass

Get started