Frigidaire Dishwasher Error Code ER/CE

ER/CE stands for Configuration Error on a Frigidaire dishwasher. It means the main control board has detected a problem with its stored configuration data, either because the data is corrupted or because the board does not match the dishwasher's model requirements. The dishwasher will not operate normally while this code is active. Resolving it typically involves resetting the unit or inspecting and replacing the control board.

A power reset will sometimes clear ER/CE if the error was triggered by a one-time electrical disturbance that corrupted temporary memory. However, if the underlying cause is a faulty control board or an incorrectly matched replacement board, the code will return after the unit powers back on. A reset is a useful first step, but it is not a permanent fix if the hardware is at fault.

If a control board replacement is needed, parts and labor costs typically range from $150 to $400 depending on the specific model and local labor rates. If the error is resolved by a simple power reset, there is no parts cost involved. Getting a diagnostic from a technician before purchasing parts can help avoid unnecessary expenses.

You can attempt a basic reset by disconnecting power to the dishwasher at the circuit breaker for at least one minute, then restoring power. If the code clears and does not return, the error was likely caused by a temporary power event. If the code returns, the issue involves the control board and may require a qualified technician to inspect or replace the component.

The dishwasher is designed to stop normal operation when ER/CE is active to prevent running a wash cycle with incorrect configuration settings. Attempting to force the unit to run in this state is not recommended, as the control board cannot guarantee the correct cycle parameters are being applied. It is best to resolve the error before resuming use.