Frigidaire Dishwasher Error Code OPTION LED's Flashing

When all option LEDs flash on a Frigidaire dishwasher, it means the control board has detected that a power failure occurred. The dishwasher lost its stored cycle and option selections when power was interrupted, and it is alerting you to reselect your settings. This is an informational status alert, not a component failure code. Press START/CANCEL, choose your desired cycle and options, and press START to resume normal operation.

Yes, pressing the START/CANCEL pad is the recommended reset step and should clear the flashing LEDs. If that does not resolve it, you can also try switching the dishwasher's circuit breaker off for 30 seconds and then back on to perform a hard reset of the control board. After restoring power, reselect your cycle and options before starting.

In most cases there is no repair cost at all, since the flashing LEDs simply require pressing START/CANCEL and reselecting your cycle after a power interruption. If the issue is caused by a faulty outlet or loose wiring, an electrician's service call typically runs between $75 and $200 depending on your area. In the rare case where a failing control board is responsible for repeated false alerts, control board replacement parts and labor can range from $150 to $400.

Press the START/CANCEL pad to acknowledge the alert and clear the flashing lights. Then reselect the wash cycle and any options you want, and press START to begin the cycle. If the LEDs continue to flash or the issue recurs frequently, check your home's circuit breaker and the power connection to the dishwasher for any problems.

Yes, the flashing option LEDs indicate a power interruption alert rather than a safety hazard or component failure. The dishwasher is simply waiting for you to reconfirm your settings before running. Once you press START/CANCEL and reselect your cycle, the unit should operate normally and safely.