GE Washer Error Code E15

E15 means the inverter control has detected an open circuit in one of the three motor phases, with no speed feedback present. When this condition occurs, the inverter bridge is shut off immediately to protect the motor and electronics. The washer will not operate until the fault is diagnosed and resolved. The problem typically originates in the wiring between the inverter board and the motor.

No. The washer's control system shuts the motor down immediately when E15 is triggered precisely to prevent further damage. Attempting to force operation with an active open-phase fault could stress the inverter board or motor windings. The machine should remain unplugged until the electrical fault is identified and corrected.

Repair cost depends on the root cause. If the fix is simply reseating a loose connector or cleaning a corroded terminal, there may be no parts cost at all. A replacement motor harness or motor can range from roughly $50 to $200 in parts depending on the specific model. An inverter board replacement typically runs between $100 and $300 in parts. Adding professional labor will increase the total, generally by $100 to $200 or more depending on your area.

In many cases, yes. Start by unplugging the washer and inspecting the wire harness connectors between the inverter board and the motor for loose, corroded, or damaged connections. Reseating a connector or cleaning corroded terminals requires no special tools and no parts. If the wiring is intact, further diagnosis involving motor winding resistance testing or inverter board replacement is still within reach for a knowledgeable DIYer with a multimeter.

A reset may temporarily clear the displayed code, but the error will return as soon as the washer attempts to run the motor again if the underlying fault is still present. The open circuit condition is detected during motor operation, so the code is not a stored fault that disappears with a reset. Clearing it permanently requires repairing the wiring, motor, or inverter board.