mypros+
Model reference

GE WPDH8800J

Washer

10 documents30 error codes5 service modes

Available documentation

Service Manual

  • New GE Profile Front Load Washer WPDH8800J68 pg
    Covers this model
  • GE Profile Front Load Washer Technical Service Guide60 pg
    Covers this model
  • GE Consumer & Industrial Technical Service Guide - Profile Front Load Washer60 pg
    Covers this model
  • Profile HA Washer Service Manual75 pg
    Covers this model

Tech Sheet

  • Profile Washer with Steam Cycle Options24 pg
    Covers this model

Tech Tip

  • WPDH8800J Profile Washer / SPBD880J Pedestal1 pg
    Covers this model

Training

  • Profile Front Load Washer Tips4 pg
    Covers this model
  • Profile Front Load Washer Tips4 pg
    Covers this model

Other

  • 1 Lav Frontale WPDH880068 pg
    Covers this model
  • 31 16571 1 GE Washer Mini Manual WPDH8800J1MG8 pg
    Covers this model
MyPros+ Max

Diagnose your GE WPDH8800J.

  • Step-by-step diagnostics from the service manual
  • Test values, resistance specs, and wiring references
  • Verified part numbers when replacement is needed
Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass

Error codes (30)

CodeMeaning
E1Internal problem with UI EEPROM on the User Interface or Machine Control board.E10Communication problem between Machine Control and Motor Drive.E11Door lock assembly problemE12Door unlock assembly problemE13Door open assembly problemE14Overflow errorE15Open circuit detected in any of three motor phases.E16Motor Drive operation above design limits (over trip).E17ADC fault eventE18Heatsink over temperature on motor drive.E19Motor over temperature.E2Internal problem with Power EEPROM on the User Interface or Machine Control…E20Overload current detected on motor drive.E21Overload power detected on motor drive.E22Over voltage detected at motor drive.E23Under voltage detected at motor drive.E24Under voltage detected after start at motor drive.E25Motor drive internal problemE26LIN communication failure between Machine Control and User Interface Control.E28Unexpected door unlock detected during cycle.E3Inverter EEPROM fault eventE38Dispenser motor failure.E39Dispenser motor failure.E4Water temperature sensor (thermistor) shorted.E5Water temperature sensor (thermistor) open circuit.E6Water level sensor (pressure switch) problem.E62Dispenser motor failure.E7Slow fill problemE8Drain system problemE9Dispenser motor problem

Service modes (5)

  • Demo ModeUnplug washer
  • diagnostic_steam_testEnter Service Mode, then select 'Steam Test' in diagnostic mode.
  • Service ModeWith the unit in idle (blue screen is blank), press
  • Service Test Mode["Press POWER button to clear any current cycles (display must be blank).","Press EXTRA RINSE, then…
  • service_modeEnter Service Mode (specific button sequence not detailed in this document).

Full entry steps, exit procedures, and test sequences are available in Max.

Related GE washer models

78,000+ service manuals · 160,000+ error codes · 55+ brands

Get Started

$29/month · Cancel anytime · Or $9.95 3-day pass