KitchenAid Dishwasher Error Code F6E2

F6E2 indicates an electrical problem in the fill valve circuit. This can be caused by a loose wire connection, an open fill valve solenoid, a blown fuse on the control board that protects the fill valve, or a faulty fill valve drive circuit on the control board. The dishwasher stops operation when this fault is detected to prevent running without a proper water supply.

You should not attempt to run the dishwasher while F6E2 is active. The fault indicates the fill valve circuit is not functioning correctly, which means the dishwasher may not fill with water properly. Running a cycle under these conditions can damage the pump and other components.

Repair costs vary depending on the specific cause. A replacement fill valve typically costs in the range of $30 to $80 for the part alone, while a replacement control board can range from $100 to $250 or more. Adding professional labor, total repair costs can range from $100 to $400 depending on which component has failed and local service rates.

Start by unplugging the dishwasher or disconnecting power, then use a multimeter to check the resistance of the fill valve solenoid and test continuity through all wiring connections in the fill circuit. If the solenoid reads open (OL) on your meter, the fill valve needs to be replaced. If wiring and the solenoid are good, check the control board fuse and then the board itself.

A reset may temporarily clear the code, but if the underlying electrical fault in the fill valve circuit has not been repaired, the error will return as soon as the dishwasher attempts to fill. The root cause, whether a loose connection, a failed solenoid, or a board issue, must be identified and corrected for the code to clear permanently.